anko 3 Way Power Light Strip User Manual

anko 3 Way Power Light Strip User Manual

Please read all the information carefully before you use the device, keep it for future reference.

Safety instructions

Please read all safety instruction warnings carefully before using this product. Improper use of this product may resultin damage to this or attached products. To ensure the product works well, please never use in the following conditions:

1. Near heaters or in high temperatures.
2. In direct sunshine.
3. Do not use chemical solvents to clean this product.

Packing contents

• 1.2m LED Strip Lights x 1
• 3m USB cable with touch switch x 1
• Car Charger x 1
• Alligator clip x 1
• Carry bag x 1
• User manual x 1

Operating Instructions

(3 ways to light up the Light strips)

1.  Alligator clip: connect the USB cable to the light strip ( follow Arrow logos on both of USB cable and light strip ends) and screw the cap, connect the USB connector to the car charger, insert car charger into the alligator clip socket and link the clips with cor accumulator;
2. USB: connect the USB cable to the light strip ( Follow Arrow logos on both of USB cable and light strip ends) and screw the cap, connect the USB connector with USB port rated DC5 V;
3. Car charger: connect the USB cable to the light strip ( Follow Arrow logos on both of USB cable and light strip ends) and screw the cap, connect the USB connector with the car charger, insert the car charger into the car lighter socket rated DC 12V;
4. Place the light strips on the tent, Caravan annex, 4WD.
5. Use the touch switch to power on and change light color and lighting brightness.

Note:

1. Please note the direction when connecting the strip light to USB cable;
2. Please note the positive and negative poles when connecting the car accumulator;
3. After using, please disconnect the powering end first and then other parts, rolling up the light strip and putting it into the carry bag with other accessories.

Specification

• 3 Powering Ways: USB, Car charger, Alligator clip
• Light Color: RGB (8 colors: Red/Blue/Green/Purple/Pink/Yellow/Light blue /White)
• LED Tbype: 5050 SMD
• Input: DV 12V and 5V
• Light Strip Wire Lengbth:1.2 m

12 Month Warranty

Thank you for your purchase from Kmart.

Kmart Australia Ltd warrants your new product to be free from defects in materials and workmanship for the period stated above, from the date of purchase, provided that the product is used in accordance with accompanying recommendations or instructions where provided. This warranty is in addition to your rights under the Australian Consumer Law.

Kmart will provide you with your choice of a refund, repair or exchange (where possible) for this product if it becomes defective within the warranty period. Kmart will bear the reasonable expense of claiming the warranty. This warranty will no longer apply where the defect is a result of alteration, accident, misuse, abuse or neglect.

Please retain your receipt as proof of purchase and contact our Customer Service Centre on 1800 124 125 (Australia) or 0800 945 995 (New Zealand) or alternatively, via Customer Help at Kmart.com.au for any difficulties with your product. Warranty claims and claims for expense incurred in returning this product can be addressed to our Customer Service Centre at 690 Springvale Rd, Mulgrave Vic 3170.

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality and the failure does not amount to a major failure.

For New Zealand customers, this warranty is in addition to statutory rights observed under New Zealand legislation.

References

• Kmart.com.au

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>