NINJA Foodi SS351 Power Pitcher System User Guide
- June 6, 2024
- Ninja Foodi
Table of Contents
Please make sure to read the enclosed Ninja® Owner’s Guide prior to using your unit.
What’s in the Box
Use to remove excess residue when cleaning, such as when dealing with stuck-on ingredients, like doughs and batters. AUTO-iQ ® MODE.
Intelligent pre-set programs combine unique blending and pausing patterns that do the work for you. Once a preset program is selected, it will start immediately and automatically stop when blending is complete.
SMOOTHIE
Fruit Smoothies
Frozen Drinks| CHOP
Mirepoix
Veggie Chop| SPREAD
Sauces
Dips| DOUGH
Cookies
Pizza| BOWL
Smoothie Bowl
Sorbet
---|---|---|---|---
Use drinkable
programs with the
Power Nutri™ Cup| EXTRACT
Green Drinks
Refresher| SMOOTHIE
Fruit Smoothies
Protein Drinks
---|---|---
Use spoonable
programs with the
XL Power Nutri Bowl| SPREAD
Nut Butter
Hummus| BOWL
Smoothie Bowl
Fro-Yo
---|---|---
MANUAL MODE
Go manual for total control of your blending speed and textures. Dial down the
speed for heavy loads like dough, or crank up the speed for smoothies.
Continuously runs up to 60 seconds. Press START/STOP at any time to end the
program sooner.
NOTE: In Manual mode, Auto-iQ® programs will not illuminate on the
control panel.
USING TOTAL SPEED CONTROL & THE POWER PITCHER
NOTE: IF USING MANUAL SPEEDS WITH THE DOUGH BLADE ASSEMBLY, ONLY USE SPEEDS 1 OR 2.
START SLOW | DIAL-UP THE SPEED | HIGH-SPEED BLENDING |
---|
Always start at a low speed (1–3) to better incorporate ingredients and
prevent them from sticking to the sides of the vessel.| Smoother blends call
for higher speeds. Low speeds are great for
chopping veggies and mixing dough, but you’ll need to ramp up for purees and
dressings.| Blend until your desired consistency s reached. The longer you
blend, the better the breakdown and smoother the outcome will be.
Assembling the Power Pitcher
- Holding the blade assembly by the top of the shaft, insert it into the pitcher.
- Fill pitcher with desired ingredients. Install the lid, then lower lid handle to lock in place.
- Place pitcher on base. Slightly align the handle to the right so the LOCK symbols are visible on the motor base. Rotate clockwise until the pitcher clicks into place.
Blending
PRESS THE POWER BUTTON TO TURN THE UNIT ON.
- Use the dial to select an Auto-iQ® program or manual speed, then press START/STOP to begin blending.
- When blending is complete, turn the pitcher counterclockwise and lift to remove.
- To pour out thinner mixtures, ensure the lid is locked in place, then open the pour spout.
NOTE: If using manual speeds with the Dough Blade Assembly, only use speeds 1 or 2.
For thicker mixtures
Press the RELEASE button and lift the handle to remove the lid, then
carefully lift out the blade assembly before removing the contents.
Remove contents from blade assembly by using a spatula.
WARNING: Blade assembly is sharp and not locked in place. Make sure lid is locked onto the pitcher before pouring contents. If pouring without lid, carefully remove blade assembly first. Failure to do so will result in a risk of laceration. Refer to the Ninja Owner’s Guide for additional information.
Dough making 101
Loading tips for making different doughs and batters.
COOKIES
Unit can make a max of 24 one (1) ounce cookies at a time.
- Add sugars; cubed, softened butter; eggs; and liquids (such as vanilla extract). Use the dial to select DOUGH, then press START/STOP.
- Add all dry ingredients and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
- Remove dough blade and add mix-ins (such as chocolate chips, raisins, and nuts). Stir to combine.
PIZZAS, PRETZELS, BAGELS & BREAD DOUGHS
Unit can make a max of one 12″ round pizza, 8 pretzels or bagels, or one loaf
of bread at a time.
- First add liquids (such as water), yeast, and oil. Then add dry ingredients. Use the dial to select DOUGH, then press START/STOP.
- Remove the dough ball and knead to combine if needed.
BISCUITS, PIES & SCONES
Unit can make a max of 8 biscuits and scones or one 12″ round pie crust at
a time.
- First add dry ingredients and cold, cubed butter or shortening. Use the dial to select DOUGH, then press START/STOP.
- Add cold liquids (such as cold milk or water) and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
- Remove the dough ball and knead to combine.
CAKES, BROWNIES, MUFFINS & QUICK BREAD
The unit can make a max of one 12″ round cake, one 8″x8″ pan brownies, 12
muffins, or one 8″x4″ loaf of quick bread, such as banana bread or pumpkin
bread.
- Add sugars; oil or cubed, softened butter; eggs; and liquids (such as vanilla extract). Use the dial to select DOUGH, then press START/STOP.
- Add all dry ingredients and run the DOUGH program again. If more mixing is needed, run on Speed 2 until combined.
- Add mix-ins (such as chocolate chips, raisins, and nuts). Press iQ/Manual, and, with Speed 1 selected, press START/STOP. Blend until combined.
Food prep 101
PREPPING VEGETABLES
- Cut both ends off ingredients and remove any outer peels or skins.
- Cut ingredients such as carrots, cucumber, celery, and zucchini in 2″ pieces, and broccoli or cauliflower florets into 1″ pieces. Cut ingredients such as onions in quarters.
PREPPING MEAT
- Trim excess fat and connective tissue. Cut meat in 2″ cubes.
CHOP PROGRAM
- Timed pulses and pauses give you consistent chopping results.
- Run the program once for a large chop, twice for a small chop, and three times for a mince.
Assembling the XL Power Nutri™ Bowl & Power Nutri Cup
- Fill the container with desired contents. Screw on the blade assembly until you have a tight seal.
- Flip container upside down and install on base. Rotate clockwise until it clicks into place.
Blending
PRESS THE POWER BUTTON TO TURN THE UNIT ON.
- Use the dial to select an Auto-iQ® program or manual speed, then press START/STOP to begin blending.
- If using the XL Power Nutri Bowl, twist the Power Paddle counterclockwise continuously while processing.
- When blending is complete, remove the container from base. Then, remove the blade assembly from container.
Taking It To Go?
Place the Storage Lid or Spout Lid on top
of the bowl or cup, and turn clockwise to seal.
NOTE: DO NOT microwave or freeze the XL Power Nutri Bowl or Power Nutri
Cup.
WARNING: Handle the blade assembly with care, as the blades are sharp.
DID YOU KNOW?
Smoothie bowls are thicker & spoonable, compared to smoothies which are
thinner & drinkable.
SMOOTHIE BOWL
BASICS
USING THE XL POWER NUTRI™BOWL
-
Add milk, or milk alternative such as soy, coconut, almond, or oat milk, up to the LIQUID FILL line.
ALWAYS DO THIS FIRST. -
Add frozen fruit, directly from freezer, and/or açai or dragon fruit packets, up to the MAX FILL line.
Cut larger fruit, like bananas, in quarters. If using açai or dragon fruit packets, thaw slightly and cut in quarters. -
(Optional)
Amplify your base by adding 1 scoop of yogurt, flavor powder, protein powder, and/or nut butter. -
Screw on the blade assembly and install the bowl on the motor base. Select BOWL and press START/STOP. Twist the Power Paddle counterclockwise continuously while processing.
-
After blending is complete, add your favorite toppings, such as coconut flakes, granola, fresh bananas, berries, and agave nectar.
Cleaning
STUCK-ON INGREDIENTS IN THE XL POWER NUTRI ™ BOWL?
NOTE: For best results, use a dishwasher to remove stuck-on ingredients.
- Rinse the bowl and blade assembly under WARM WATER after processing.
- Fill the bowl with warm water up to the top of the Power Paddle and add 1 or 2 SMALL DROPS of dish soap.
- Select BOWL and press START/STOP. Twist the Power Paddle counterclockwise continuously while processing.
- Once complete, empty contents and rinse under warm water.
NOTE: The Power Paddle in the XL Power Nutri Bowl is not removable.
STUCK-ON INGREDIENTS IN THE PITCHER OR CUP:
Fill pitcher with warm water up to the DOUGH MAX line and add 1 or 2 small
drops of dish soap. For the cup, fill halfway with warm water and add 1 small
drop of dish soap. Run the BOWL program. Once complete, empty contents and
rinse under warm water. Refer to the Owner’s Guide for more information.
Dishwasher
Containers, lids, and blade assemblies are all top-rack dishwasher safe.
Hand-Washing
Wash containers, lids, and blade assemblies in warm, soapy water. When washing
the blade assemblies, use a dishwashing utensil with a handle. Use the
included cleaning brush to remove excess residue, such as when dealing with
stuck-on ingredients, like doughs and batters.
WARNING: Handle the blade assemblies with care when washing, as the blades are sharp. Contact with the blades’ edges can result in laceration.
For questions or to register your product, visit us online at ninjakitchen.com
@ninjakitchen
© 2020 SharkNinja Operating LLC.
AUTO-IQ, NINJA, FOODI, and TOTAL CRUSHING are registered trademarks at
SharkNinja Operating LLC.
HYBRID EDGE and POWER NUTRI are trademarks of SharkNinja Operating LLC.
CO351B_QSG_MP_Mv1
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>