ScreenBeam SBWD750E 750 Wireless Display Receiver User Guide
- June 6, 2024
- ScreenBeam
Table of Contents
ScreenBeam 750
Wireless Display Receiver
User Guide
quick start guide
Catalog Numbers: SBWD750E, SBWD750W
This guide provides step-by-step instructions on how to set up and configure ScreenBeam wireless display receiver for deployment. After completing the steps described in this guide, you will be able to place the receiver at your site and provide a wireless display to users.
Helpful Resources
Before deploying ScreenBeam products, check for the latest firmware and release documentation.
- For ScreenBeam receiver’s deployment guide, firmware upgrades, and release notes go to: https://support.screenbeam.com/750.
- For an online tutorial on how to connect your Wi-Fi Miracast or WiDi client device to ScreenBeam, go to:
www.screenbeam.com/setup.
Package Contents
- ScreenBeam 750 wireless display receiver
- Power supply
- HDMI cable
- HDMI-to-VGA dongle and 3.5mm audio cable
- Quick Setup Guide (this document)
- Regulatory flyer
Setup Requirements
- TV/projector/monitor with available HDMI input
- Windows 10 device with Wi-Fi Miracast wireless display
A. Connect Receiver to Display
Figure 1 Connection guide
-
Place the receiver next to the display.
-
Using an HDMI cable, connect one end to the receiver’s HDMI port and the other end to the HDMI port on the TV.
Note: If a VGA connection is preferred, refer to the ScreenBeam receiver’s user guide for more details. -
Connect one end of the receiver’s power supply to the receiver’s power port and the other end to an electrical wall outlet.
-
Turn on the display and switch to the HDMI input to which the receiver is connected.
-
Wait about 30 seconds, then verify the Ready to Connect screen appears on the display.
B. Connect From Your Device
-
For an online tutorial on how to connect your Wi-Fi Miracast client device to ScreenBeam, go to: www.screenbeam.com/setup.
-
Using a Windows 10 client device, connect to the receiver’s name as displayed on the Ready to Connect screen.
-
Enter in the PIN code if required.
Note: If the PIN code does not show on the display, then try the default code -
The client device’s screen appears on the display.
Tip: Press hotkeys Windows + P and select a project mode.
Congratulations! Your TV/Projector is now enabled with wireless display.
For FAQs, troubleshooting tips, and support, go to:
https://support.screenbeam.com.
P/N 0530-0795-003
© 2020 All rights reserved. ScreenBeam and the ScreenBeam logo are registered
trademarks owned by ScreenBeam Inc. All other names are properties of their
respective owners. Specifications are subject to change without notice.
040320-wfh
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>