Energizer Motion-Activated LED Wall Sconce User Guide
- June 6, 2024
- Energizer
Table of Contents
Energizer Motion-Activated LED Wall Sconce
BATTERY INSTALLATION:
This product requires 6 AA batteries to function (sold separately).
- Remove the battery cover.
- Insert 6 AA batteries, noting polarity.
- Replace the battery cover.
IMPORTANT : Different types of batteries or new and used batteries should not be mixed. Exhausted batteries should be removed from the fixture and disposed of properly.
MOUNTING INSTRUCTIONS:
- Lightly mark the screw locations with a pencil using the included mounting template.
- Use a 3/16”drill bit to pre-drill holes for the anchors.
- Seat the anchors into the pre-drilled holes.
- Insert each screw and fasten them in place with a screwdriver. Leave the screw heads protruding approximately 1/8” from the surface.
- Align the mounting holes on the sconce with the screws and fully mount the product onto the surface.
OPERATION:
Use the ON/AUTO/OFF switch on the side of the sconce to select your preferred
setting.
ON: The light remains ON until the batteries are depleted.
AUTO: The built-in motion sensor activates the light when motion is
detected within 15ft. After 20 seconds of inactivity, the light will turn OFF.
The light also has a dusk-to-dawn feature that makes that light only turn on
in low light conditions.
OFF : The light is inactive and battery power will not be
used.
©2020 Energizer. Energizer and certain graphic designs are trademarks of
Energizer Brands, LLC and related subsidiaries and are used under license by
Jasco Products Company, LLC.
Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM-8PM CST.
90-day warranty. Visit www.byjasco.com for warranty
details.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>