Energizer 38558T2CB Wireless Remote Control 10 Inch Light Bar User Manual
- June 2, 2024
- Energizer
Table of Contents
Energizer 38558T2CB Wireless Remote Control 10 Inch Light Bar
Battery Operated Light Bar, Wireless Remote Control, 12in
Battery Operated Light Bar, Wireless Remote Control, 10in
BATTERY INSTALLATION
Open the battery compartment on the back of the light by sliding the back cover in the direction of the arrow. Insert 6 AA batteries, noting polarity. Replace cover by sliding in opposite direction.
REMOTE
NOTE: Remove battery isolation tab for first time use. To replace
exhausted battery, unscrew the battery door on the back of the remote. Insert
2 CR2032 batteries, noting polarity.
Replace the cover and screw back in.
IMPORTANT: Different types of batteries or new and used batteries should not be mixed. Exhausted batteries should be removed from the fixture and disposed of properly.
REMOTE OPERATION
-
Switch to “RF” for remote control functions (See Fig. 1).
NOTE: To control multiple light bars, all light bars must be in “RF” position. -
On the remote, press the “I” button to turn the lights on.
-
Press the “O” button to turn the lights off.
MANUAL OPERATION
- Move switch to ON position to turn the light on.
- Move switch to OFF position to turn the light off.
MOUNTING INSTRUCTIONS
NOTE: Mounting template is provided under the product.
To mount light: Remove battery cover and mount in desired location using
screws and the included mounting template or double-sided tape. Reattach light
to mounted battery cover.
Anchors are included for installing screws in the sheetrock.
NOTE: Battery door may remain mounted when changing batteries.
Functional range may be adversely affected by one or more of the following
factors: weather, radio frequency interference, low battery in remote or
obstructions between the transmitter and receiver.
FCC NOTE: The manufacturer is not responsible for any radio or TV interference caused by unauthorized modifications to this equipment. Such modifications could void the user’s authority to operate the equipment.
FCC STATEMENT: This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device must not be co-located or operating in conjunction with any other antenna or transmitter. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Read instructions or watch easy-to-follow video. Scan QR code or visit https://byjasco.com/44575i
MADE IN CHINA/HECHO EN CHINA
©2020 Energizer. Energizer and certain graphic designs are trademarks of Energizer Brands, LLC and related subsidiaries and are used under license by Jasco Products Company, LLC.
Contact our U.S.-based Consumer Care at
1-800-654-8483 between 7AM-8PM CST
90-day warranty. Visit www.byjasco.com for warranty
details.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>