SATCO S11938-12T8 LED T8 Tube Bulb Instruction Manual
- June 4, 2024
- SATCO
Table of Contents
SATCO S11938-12T8 LED T8 Tube Bulb Instruction Manual
Product Features:
- c-UL-us Classified and Recognized
- Full glass housing: No aging yellowing bending
Product Applications:
Widely used in residential buildings, offices, shopping malls, supermarkets. hospitals, assembly lines, warehouses. etc. for energy saving illumination.
Installation Instructions:
Please completely comply with these instructions and notes. to ensure that the product is operated in a safe condition.
A Safety Precautions:
For your and others’ safety, please read the precaution carefully before installation:
- Product should be installed by qualified electrician.
- Switch off the power supply before commencing work, make sure connection is correct before tuming power on.
- Do not apply uncertified LED driver with the product.
Wiring Instruction – Electronic Ballast
Retrofit luminaire with 1 lamp
Retrofit luminaire with 2 lamps
Retrofit luminaire with 3 lamps
Retrofit luminaire with 4 lamps
Wiring Instruction – Magnetic Ballast
Retrofit luminaire Magnetic Ballast
WARNINGS:
WARNING- Risk of fire or electric shock. Luminaire wiring and electrical parts may be damaged when drilling for installation of LED retrofit kit. Cheek for enclosed wiring and components.
WARNING- Risk of fire or electric shock. LED Retrofit Kit installation requires knowledge of luminaires electrical systems. If not, do not attempt installation. Contact a qualified electrician.
WARNING- Risk of fire or electric shock. Install this kit only in luminaires that have the construction features and dimensions shown in the photographs and/or drawings and where the input rating of the retrofit kit does not exceed the input rating of the luminaire.
WARNING-To prevent damage to wiring, do not expose wires to the edges of sheet metal or other sharp objects.
THIS RETROFIT KIT IS ACCEPTED AS A COMPONENT OF A LUMINAIRE WHERETHE SUITABILITY OFTHE COMBINATION SHALL BE DETERMINED BY AUTHORITIES HAVING JURISDICTION.
Installers should not disconnect existing wires from lamp holder terminals to make new connections at lamp holder terminals. Instead installers should cut existing lamp holder leads away from the lamp holder and make new electrical connections to lamp holder lead wires by employing applicable connectors. All electrical connections shall be provided within an enclosure.
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit installation.
NOT FOR EMERGENCY LIGHTING.
The units covered by this report were intended to retrofit surface mount with diffsuer, Type IC or non-IC recessed mount Listed fluorescent luminaires that use maximum two lamps, the minimum lamp compartment dimensions are tabulated below.
Model| Minimum Luminaire dimensions [Length xWidth x Height] [cm]|
Lamp
Quantity
---|---|---
S11938-12T8/LED/48-830/XD S11939-12T8/LED/48-835/XD
S11940-12T8/LED/48-840/XD S11941-12T8/LED/48-850/XD| 121.5 x 60.5 x
7.5| 2
Tested with below ballast. See instructions or website for more information on ballast compatibility.
| Driver MFR | Driver Model | Max Lamp Quantity |
|---|---|---|
| SATCO Products, Inc. (EXXXXXX) | S801X X is range from 2-3 | 2 |
Parts/Components included in Kit
Retrofit Kit Installation Instruction| LED lamps
Luminaire Markings (Affixed to Luminaire)| LED drivers
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received, including interference that may cause undesired operation.
Satco Products, Inc
110 Heartland BIvd.Brentwood, NY 11717
www.satco.com
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>