ROCKVILLE Wall Mount Speaker Bracket RHSB8 Instruction Manual
- June 6, 2024
- RockVille
Table of Contents
RHSB8
ASSEMBLY INSTRUCTIONS
Thank you for purchasing the RHSB8 Wall Mount Swivel Home Theater Speaker Brackets. Please read these instructions carefully before use. Alternately you can visit vimeo.com/256145304 or scan the OR code to watch a short video, which shows you how to set this item up and how to use it. Make sure all parts are included. If any parts are missing please contact our technical helpline at 1-646-758-0144, Monday through Friday, 9 am to 5 pm EST.
speaker
platform| 
| 2 pcs
---|---|---
mounting bracket| 
| 2 pcs
bracket cover| 
| 2 pcs
speaker platform support| | 2 pcs
carriage bolt| 
| 4 pcs
locking bolt| | 2 pcs
anchor| | 4 pcs
large washer| | 2 pcs
small washer| | 4 pcs
adhesive foam pads| | 4 pcs
locking knot)| | 2 pcs
Bracket Mounting Instructions:
Press the plate of the bracket up against the wall so that its flush. Make sure its level uses a torpedo or small level (A). Place a mark at the top and bottom openings where your anchor holes will be (B). If you are drilling into a stud, the anchors are not necessary.
Using a drill and a 3/8- bit, make a hole where you made your first mark (C).
Repeat for your second mark. We recommend realigning the holes with the
bracket and releveling it, to make sure everything is aligned. If you are
using the anchors, make sure the holes are deep enough to accommodate them.
Insert the anchors (D) and tap in with a hammer if needed.
Place the wall bracket into
position over the holes and insert the top carriage bolt with the small washer
(El). Tighten the carriage bolt with a spanner (E2) or use a drill with a
13/32-socket bit. Insert the second screw (E3). Use a level to ensure that the
bracket is properly aligned. Now tighten the carriage bolt. Keep the level
next to the bracket to ensure that it stays aligned.
Slide the b packet cover onto the
bracket arm and push it back onto the base until it clicks into place (9. Now
slide speaker platform support onto the end of the mounting bracket arm as
shown. Align the hole in the speaker platform support (G) with the hole in the
mounting bracket arm (H).
Speaker Platform Assembly Instructions:
Slide a locking bolt through the opening at the top of the speaker platform
(A).
Align the bolt with the hole in
the Speaker platform support (B) and slide it through. The convex bottom of
the speaker platform should rest snugly on the support piece.
Once the bolt is all the way through, slide on a large washer (C). Screw the locking knob onto the protruding part of the locking bolt (D). Do not tighten completely. Adjust the angle and direction of the speaker platform by tilling it or turning it to the desired position (E). Once it is properly adjusted, you may fully tighten the locking knob.
To extend the side supports, use
the screws located underneath them (F). There is one on either side. Use a
Phillips head screw driver to turn the screw counter-clockwise to extend and
clockwise to retract.
Dimensions
Foam Pad Placement Instructions:
Apply one of the 4 Included foam pads to the inside of the side supports of each speaker platform as shown in figure A.
RockvilleAudio.com
©2020 ROCKVILLE // The information presented is subject to change and or
improvement without notice
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>