Heatit Z-Repeater Dual USB 2A User Guide

June 6, 2024
HEATIT

heatit

Heatit Z-Repeater Dual USB 2A

Heatit Z-Repeater Dual USB 2A

INTRODUCTION

The Heatit Z-Repeater Dual USB 2A is a multifunctional AC Z-Wave range extender with two USB power adapters that allow you to charge two devices at the same time. Ideal for extending the
Z-Wave signal to areas with blind spots – a solution for anyone experiencing poor wireless connectivity.
With the rechargeable backup batteries, the device will still be able to operate for up to 6 hours after a power failure. Important battery-operated units such as door locks, smoke detectors and burglary alarms will still work during a blackout.

ADD/REMOVE

The primary controller/gateway has a mode for adding or removing devices. Please refer to your primary controller manual on how to set the primary controller in add/remove mode.
The device may only be added or removed from the network if the primary controller is in add/remove mode. When the device is removed from the network, it will revert to factory settings.

1. Connect the Heatit Z-Repeater into a power socket.
2. Set the primary controller in add/remove mode (security/non-security).
3. Within 1,5 seconds press the function button 3 times.

The Heatit Z-Repeater is now successfully added/removed.

function

TECHNICAL DATA

  • Protocol: Z-Wave, 868,4MHz
  • Chip: Z-Wave 500 chip
  • Rated voltage: 240V AC, 50 / 60Hz
  • Output effect: 10W (5V DC 2A)
  • Battery capacity: 200mAh rechargeable batteries
  • Battery life: Maintains mesh network for up to 6 hours in case of power failure
  • Ambient temperature: 0°C to 45°C
  • Humidity: Max. 85% RH
  • Plug type: Type F (Schuko)
  • Range RF: Min. 40 meters
  • Size (LxWxH): 66 x 55 x 55mm
  • Approvals: Z-Wave Plus CE

Heatit Controls AB can not be held liable for typographical errors, other errors or omittances in our information. Product specifications may change without further notice. All electrical installations must be carried out by a licensed electrician. The product must be installed in accordance with national building codes and our installers manual.

Heatit Controls AB l Läkarvägen 4, 454 31 BRASTAD, SWEDEN Phone: +47 61 18 77 77 l post@heatit.comwww.heatit.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals