heatit 5430131 External Room Sensor User Guide
- June 4, 2024
- HEATIT
Table of Contents
heatit 5430131 External Room Sensor
INTRODUCTION
Heatit External Room Sensor is designed for use with Multireg and Heatit
thermostats. The sensor can be mounted directly on a wall or on the outside of
a wall box. Fits into System-55 frames. The product is delivered in a matte
finish. When used with a thermostat, dimmer or other products that emit heat,
it is recommended that the sensor be mounted below the other products.
It is not possible to connect the sensors in series or in parallel.
INSTALLATION
Installation must be done by a qualified electrician in accordance with
national building codes. Before installation, disconnect the power to the
thermostat from the mains. During installation of the sensor, power to the
thermostat must be disconnected AT ALL TIMES.
Use up to 1.5mm2 cable to connect the device to the thermostat.
The product is connected from the terminals on the product to the terminals marked with ”Sensor” on the thermostat.
TECHNICAL DATA
-
NTC
10kΩ @25°C -
Cable
Ø1.5mm2 -
Size
84 x 84 x 20mm -
IP-Code
IP 21 -
Approvals
CE
Heatit Controls AB can not be held liable for typographical errors, other errors or omittances in our information. Product specifications may change without further notice. All electrical installations must be carried out by a licensed electrician. The product must be installed in accordance with national building codes and our installers manual.
Heatit Controls AB l Läkarvägen 4, 454 31 BRASTAD, SWEDEN Phone: +47 61 18 77 77 l post@heatit.com – www.heatit.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>