heatit 1444430 EEZEDIM 250W Z-Wave Rotary Dimmer User Guide
- June 4, 2024
- HEATIT
Table of Contents
1444430 EEZEDIM 250W Z-Wave Rotary Dimmer
User Guide
HEATIT EEZEDIM 250W
Ver 2022-A
Art. no. 14 444 30
INTRODUCTION
Heatit eezedim is a rotary dimmer for many different types of light fixtures.
The Heatit ezedim works on most low loads without causing flickering.
Heatit eezedim is very well suited for LED and fits into System 55 frames.
When connecting low loads it is recommended to use a bypass.
NB! DIMMING
Dimming may be challenging, and we recommend checking the compatibility of
different light sources before installation. We are happy to answer any
questions.
MOUNTING
WIRING DIAGRAM
QUICK START
- Switch off the mains voltage (disable the fuse).
- Open the junction box.
- Connect according to the wiring diagram as shown below.
- After verifying the connections, switch on the mains voltage.
INSTALLATION AND WIRING
Installation must be done by a qualified electrical installer in accordance
with national building codes. Before installation, disconnect any power to the
dimmer mains. During the installation process, the fuse must be turned off AT
ALL TIMES!
NB! Max tightening torque for terminal screws: 2Nm
NB! This is a 2-wire dimmer so the Neutral is only connected to the load
and not the dimmer itself.
- Turn off the fuse.
- Connect the Live to the dimmer terminal marked ”L”.
- Connect the load terminal marked ”L” to the dimmer terminal marked
- Install the dimmer (A) in the wall box. Make sure that no wires are pinched.
- Attach the cover (B) with the supplied nut (C).
- Attach the button (D) with a simple push.
CONTROL
EXTERNAL TOGGLE SWITCH
The Heatit eezedim has the option for an external toggle switch, making it possible to turn on/off the dimmer with the external switch.
FEATURES
• Rotary dimmer| • Overload protection
• 2-wire| • Surge protection
• 5W – 250W LED| • Overheat protection
• Nemko certified| • Min. dim level
• Trailing edge| • Max dim level auto-calibration
TECHNICAL DATA
Rated voltage| 230VAC 50Hz
Power| 5W – 250W
Control| Rotary dimming
Ambient temperature| 5°C to 40°C
Connection| Max. 2.5mm²
Flush mounting depth IP Code| 24mm
IP Code| IP 21
Size (LxWxH)| 84 x 84 x 43mm
Approvals| CE, Nemko
MAINTENANCE
The device is maintenance-free, but must never be covered only for indoor
installation.
Heatit Controls AB can not be held liable for typographical errors, other errors, or omittances in our information. Product specifications may change without further notice. All electrical installations must be carried out by a licensed electrician. The product must be installed in accordance with national building codes and our installers manual.
Quick Guide
Heatit Controls AB
Phone: +47 61 18 77 77 l
post@heatit.com
– www.heatit.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>