BLAUPUNKT HB4 12V Vehicle Lighting LED Headlamp Instruction Manual
- June 6, 2024
- Blaupunkt
Table of Contents
12V VEHICLE LIGHTING
LED HEADLAMP
5000K & 6000K
Enjoy it.
Operating and Installation Instructions
CAUTIONS
Safety Notes
This product has been manufactured according to established safety guidelines.
However, dangers may still occur if the safety notes in this manual is not
observed. This manual is intended to familiarize the user with the product’s
important functions. Read this carefully, prior to installing the product.
Keep this manual in an easily accessible location. In addition, do observe the
instructions of the devices used in conjunction with the product.
General Safety
- A headlamp is intended for installation and operation in a vehicle with 12V vehicle system voltage and can be used as headlights with relevant models such as H4, H7, H8/H11/H16 & HB3/HB4 halogen lamps.
- Ensure the headlamp does not have defects before installation.
- Keep the headlamp away from children.
- Keep the headlamp away from flammable areas or liquids.
- The headlamp should be stored in dry and low humidity place.
- Avoid skin contact with the high temperature/ working headlamp when replacing the headlamp. Allow the headlamp to drop to room temperature before replacing the headlight.
- Do not modify the product, or expose the product to dust, grease stains, or scratch the surface of the headlamp.
- Do not look directly at the operating headlamp, it may cause eye damage.
- After installation, ensure below are working correctly
- Correct light/beam pattern
- Indicators are working
- Wiring is connected correctly
- Covers are installed back to the car correctly
This manual may be updated from time to time without any notice.
Disclaimer
In no event shall Blaupunkt be liable for any direct, indirect, punitive,
incidental, special consequential damages to property or life and whatsoever
arising out of or connected with the use or misuse of our products. USA &
CANADA: This product is not intended for sale in the United States and Canada.
If purchased in the U.S. or Canada, this product is purchased on as-is basis.
No warranty, whether expressed or implied is provided in the U.S. or Canada.
STRUCTURE & FUNCTIONS
Applicable to : Reflector headlight
Product Name : 334250WC (5000K), 334260WC (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 12V
Luminous Flux : 2400lm ±20%
Water Resistant Rating : IP67
Lifespan : 20,000 hour
Colour Temperature : 5000K & 6000K
Base : P43t
Applicable to : Projector, reflector & fog headlight
Product Name : 397250WC (5000K), 397260WC (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 12V
Luminous Flux : 2400lm ±20%
Water Resistant Rating : IP67
Lifespan : 20,000 hour
Colour Temperature : 5000K & 6000K
Base : PX26D
SPECIFICATIONS
Applicable to: Projector, reflector & fog headlight
Product Name : 300650WC (5000K), 300660WC (6000K)
Technology : LED
Power : 26W±10%
Operating Voltage : 12V
Luminous Flux : 2400lm ±20%
Water Resistant Rating : IP67
Lifespan : 20,000 hour
Colour Temperature : 5000K & 6000K
Base : P20d/P22d
TROUBLESHOOTING
If any of the following problems occur, please resort to Troubleshooting for possible solutions. Consult Blaupunkt authorized dealer if the problem persists.
| Problems | Causes | Solutions |
|---|---|---|
| One of the headlamps doesn’t work | The headlamp has burned out. | Replace with |
a new headlamp.
Both headlamps don’t work| The fuse has blown.| Replace with a new fuse.
Incorrect wiring connections.| Examine if positive and negative power
connectors are connected correctly.
No power to the circuit, bad ground or failed switch.| Examine if the wiring
for power, ground, or switch are connected correctly.
Dim Headlight| Broken alternator or power supply problem.| Examine if the
power supply voltage is correct.
Weak car battery.| Recharge the weak car battery or replace it with a new car
battery.
DISSEMBLING
- Open the hood of the vehicle.
- Find the installed location of the original halogen bulb.
- Remove the halogen bulb from the headlight housing.
H4/H7 INSTALLATION
Applicable for H4 & H7
- Remove the cap plate from the headlamp.
- Insert the cap plate and secure it with the retaining spring clip.
- Install the headlamp into headlight housing and turn clockwise to secure it.
- Please ensure the diodes (LED chips) of the headlamp are in a side-to-side orientation.
- Connect the headlamp cable to the vehicle wiring harness.
H8/H11/H16 & HB3/HB4 INSTALLATION
Applicable for H8/H11/H16 & HB3/HB4
- Install the headlamp into the headlight housing and turn clockwise to secure it without removing the cap plate.
- Please ensure the diodes (LED chips) of the headlamp are in a side-to-side orientation.
- Connect the headlamp cable to the vehicle wiring harness.
- A warning canceller adaptor may be needed in case the warning signal lights up after installation.
- Remove bulb, turn it 180° & reinstall in case bulb does not light up.
- Fit for 12V vehicle only.
Attention for H4 Installation :
https://taplink.cc/blaupunkt.apac
334260WC H4 6000K
1 581 21 044 42 01
397260WC H7 6000K
1 581 21 045 42 01
336660WC H8/H11/H16 6000K
1 581 21 046 42 01
300660WC HB4 6000K
1 581 21 047 42 01
Designed and engineered by Blaupunkt Competence Centre
Documents / Resources
|
BLAUPUNKT HB4 12V Vehicle Lighting LED
Headlamp
[pdf] Instruction Manual
H4, H7, H8, H11, H16, HB3, HB4, HB4 12V Vehicle Lighting LED Headlamp, 12V
Vehicle Lighting LED Headlamp, Vehicle Lighting LED Headlamp, Lighting LED
Headlamp, LED Headlamp, Vehicle LED Headlamp
---|---
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>