OLIGHT Open 2 ZR LED Rechargeable Flashlight Pen User Manual

June 6, 2024
OLIGHT

**OLIGHT Open 2 ZR LED Rechargeable Flashlight Pen User Manual

**

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

  • Open 2 Zr
    Open 2 Zr

  • Refill
    Refill

  • USB Charging Cable
    USB Charging Cable

SPECIFICATIONS

Material : Zirconium(main body).

  • HIGH: 120lumens
    Zirconium Main Body

  • MEDIUM: 60lumens
    Zirconium Main Body

  • LOW: 20lumens
    Zirconium Main Body

  • MOON: 5lumens

16m

64cd

(L)5.71 (D)0.5in
(L)145
(D)12.7mm


2.11oz / 59.8 g

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard.

PRODUCT OVERVIEW

The product is separable; the lower part is a pen, the upper part is a flashlight and a central blue ring used as a separation point.

PRODUCT OVERVIEW

  • The pen tip is protected by wax. Please remove the protective wax before writing.

CHARGING

Before first use, please fully charge the product. Unscrew the pen from the middle and store the lower part (pen). Connect the upper part to the USB power supply or computer USB port via the provided charging cable (USB power supply not included. Users can use any USB power supply of digital devices or household appliances). The LED lights up red to indicate charging, and the red will go out when it is fully charged.

Charging Instructions

NOTE:

  • Please press and hold the tail switch to unlock the product.
  • Plug in the USB cable again when it is full charged, the charging indicator will still be Red for about 30 seconds.
  • The product uses a USB-C charging interface with 4.2V 200mA constant current and voltage for charging.
    It can be fully charged in 55 minutes.

REFILL REPLACEMENT

  1. Unscrew the tip, take out the refill and remove the spring from the refill.
    Note: Please remove the spring from the refill carefully and do not stretch it.
    REFILL REPLACEMENT

  2. Install the spring with the narrow end first on the new refill, then put the new refill back into the pen and tighten the tip.

REFILL REPLACEMENT
REFILL REPLACEMENT

DANGER

  • DO NOT throw the light directly into human eyes. This may cause temporary blindness or permanent damage to the eyes.
  • DO NOT cover the flashlight with objects, the heat generated by flashlight may cause burning or even cause unexpected disasters.
  • Keep out of reach of children. DO NOT allow children to play to prevent physical harm.

WARNING

  • Beware of dropping: The refill inside is a precision assembly product, and the ball on the tip may lose its writing function if damaged.
  • DO NOT soak in water: The refill of the product uses gel ink. The ink will become diluted or unable to write after dissolved in water.

NOTICE

  • When the battery level is less than 5%, the maximum output is limited to 5 lumens.
  • The product adopts PWM dimming, which may cause noise when placed close to the radio.
  • The clip is suitable for clamping on objects not more than 3mm thick.
  • When replacing the refill, be careful not to deform the spring, as this may affect the use of the refill.
  • Writing on soft or padded surfaces may result in thicker lines.

OPERATION

Used as a pen:

Gently slide the pen push button along the L-shaped track to the bottom, the tip will appear and be locked, then you can start writing.

Release the pen push button to the top of the L-shaped track, the tip will bounce back into the pen.

Used as a flashlight:

Single-click the switch to turn the light ON (the default output is 5 lumens) / OFF.

When the flashlight is on, press and hold the switch to automatically cycle through the output.

Quickly double-click the switch to enter high mode even the flashlight is off, and quickly double-click the switch again to exit high mode.

When the light is off, press and hold the switch for one second to access the switch lockout mode. Under the lockout mode, if click the switch, the red indicator will be on to signal that the light is still in lockout mode. To unlock it, keep holding the switch for over one second until the light is on at 5 lumens.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.

Within 2 years of purchase: Contact Olight for repair or replacement.

The other no warranty fragile or low-value fittings like refill and USB cable, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use condition, the conditional quality assurance will be provided as appropriate.

EU-DECLARATION OF CONFORMITY

EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaration
qr code

SUPPORT

USA Customer Support
cs@olightstore.com

Global Customer Support
customer-service@olightworld.com

Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town,
Dongguan City, Guangdong, China.

Made in China

3.1320.6010.9001

A. 12, 29, 2020

Icons

OLIGHT logo

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals