OLIGHT Odin IR Tactical Light User Manual
- June 6, 2024
- OLIGHT
Table of Contents
USER MANUAL
Odin IR
Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!
IN THE BOX
SPECIFICATIONS
WH (WHITE LIGHT)
HIGH
1000 lumens
LOW
200 lumens
IR LIGHT(
WAVELENGTH 850NM )
HIGH
LOW
HIGH:
Max Output: 150mW
Max Runtime: 22h30min
Wavelength: 850nm
LOW:
Max Output: 30mW
Max Runtime: 91h
Wavelength: 850nm
- All above specifications are test results based on ANSI/NEMA FL1 Standard. The tests are performed when the built-in battery is fully charged.
USB MAGNETIC CHARGING CABLE — MCC3
Parameter | Specification |
---|---|
Charging cable | USB type A – magnetic charging connector, length: 0.5m |
Input | USB A – Type DC 5V 2A |
Charging pattern | CC&CV |
Maximum charging current | 2A |
Voltage of fully charged battery | 4.2V±0.05V |
Time to fully charge | 5.5 hours (For reference only. When the USB power source |
is insufficient to provide 5V 2A power capacity, the charging time will be
longer)
Charge indication| Red: charging
Green: full (over 95%) or disconnected with flashlight
PRODUCT OVERVIEW
BATTERY INSTALLATION
Please remove the protective film on the lens; and please also unscrew the tailcap to remove the insulating film within the battery compartment, then screw the tailcap back on tightly. If the battery needs to be replaced, make sure that the positive end of the new battery faces the flashlight head when you put it in.
AVAILABLE BATTERIES
• 1 x customized 5000mAh 21700 rechargeable lithium battery
CHARGING
VIBRATING POWER INDICATOR
It helps to alert if the battery is low (power<20% vibrate once every 5 minutes; power<10% vibrate once per minute; power< 5% vibrate once every 10 seconds).* Before first use please fully charge the product.
- Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a USB power source of no less than 10W (5V 2A) . The red indicator means charging, while the green indicator means charging completed (battery level>95%).
- Only charge with standard MCC3, not compatible with other MCC.
PRODUCT INSTALLATION
a. Loosen the screws and install the rail mount in its desired position, then tighten the screws.
b. Slide the product into the rail mount until you hear a click, then turn the
button 90 degrees clockwise as the mark shows to fix the product.
c.
Rotate the button 90 degrees counterclockwise to unlock the product as the
mark shows.
d. Press the button and remove the product.
REMOTE SWITCH INSTALLATION
a. Attach the magnetic remote switch to the tail of the product (make sure the
detent ring of the remote switch is unlocked).
b. Push the ring forward to fix the remote switch.
MAGNETIC REMOTE SWITCH
Quickly single click the button to turn the flashlight ON/OFF. When you press
and hold the button, the flashlight will be in momentary mode; when you
release the button, it will turn off.
When in the OFF mode, the operation of LO&HI buttons is disabled.
ICON | LIGHT SETTING |
---|---|
WH | WHITE LIGHT |
OFF | OFF |
IR | IR LIGHT |
DANGER
- DO NOT shine the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
- DO NOT cover the flashlight’s head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
- DO NOT use non-protected rechargeable batteries.
WARNING
- Keep out of reach of children.
- The tail switch may not work while immersed in sea water or other conductive media. Please try to keep it clean and dry.
- DO NOT disassemble the LEP module. Disassembly may result in irreversible damage.
- If the light is about to be put aside for a long time or be transported, please unscrew the tailcap and remove the battery to cut off the circuit.
NOTICE
- DO NOT short-circuit the tail switch cap with the ring surrounding it. The short circuit in this case will result in an electric discharge of below 18mA between them, and may lead to a complete battery drain if it is in this state for too long.
EXCLUSION CLAUSE
Olight is not liable for damages or injuries sustained resulting from the usage of the product inconsistent with the warnings in the manual, including but not limited to using the product inconsistent with the recommended lockout mode.
HOW TO OPERATE
THREE LIGHT SETTINGS AVAILABLE: By rotating the ring at the head of the
flashlight to select IR (infrared ray only), OFF, WH (white light only).
TAIL SWITCH: Click the tail switch lightly to produce a low light output
or press the tail switch hard to produce a high light output.
CONSTANT ON/OFF: When the mode switch is not positioned to OFF, single
click the tail switch for constant on. Click the tail switch again to turn it
off.
When the mode switch is positioned to OFF, all operations are disabled.
MOMENTARY ON/OFF: When the mode switch is not positioned to OFF, press
and hold the tail switch for momentary on. Release the switch and the light
will go off.
EU-DECLARATION OF CONFORMITY
EU-Declaration of Conformity can be found here:
https://olightworld.com/ec-declaration
WARRANTY
Within 30 days of purchase: Contact the original seller for repair or
replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one year warranty for all rechargeable
batteries.
USB magnetic charging cable: One year.
The other no warranty fragile or low-value fittings like lanyard and clip, you
can contact post-sale in 30 days after purchase if it has quality drawback or
damage under normal use condition. Over 30 days or damage under abnormal use
condition, the conditional quality assurance will be provided as appropriate.
USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete
product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road,
Changan Town, Dongguan City, Guangdong, China.
Made in China
Documents / Resources
|
OLIGHT Odin IR Tactical
Light
[pdf] User Manual
Odin IR, Tactical Light
---|---
References
- Olight | Illuminate Your World.
- Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>