OLIGHT SR92 Intimidator LED Flashlight 1700 Lumens Instruction Manual

Operator’s Manual
SR92 Intimidator

Introduction

SR92 Intimidator
SR92 is one member of high power LED flashlights series made by Olight, 3 CREE XM-L LEDs with independent aluminum alloy reflector inside, output luminous flux up to 1700 lumens maximum, smooth and wide light spot, and long throw. Its active thermal management system guarantees the flashlight runs stably and safely.
It is the best choice for outdoor adventure, hunting, searching, and rescuing.

Specification

• LED: 3 x Cree XM-L T6

• Reflector: Smooth Reflector, aluminum alloy

• Battery Pack: 7.4V 6000mAh rechargeable

• Output Luminous Flux/Runtimes:
  —High Level: 1700 lumens /2.5 hours
  —Low Level: 450 lumens /11 hours
  —Strobe: 10Hz (frequency)

• Dimension: Head: D100mm Body: D48.4mm Total Length: 273mm

• Material: Aluminum alloy body with type-III hard anodization

• Weight: 1180g

• Color: Black

• Accessories: Strap x 1 ,Charger x 1, 0-ring x 1 , Car charger x 1(optional)

Features

• 3 world-class CREE XM-L LEDs, output up to 1700 lumens max( OTF)
• 1000 meters long throw, smooth and large light spot can cover wide range
• Large capacity battery, the highest efficient synchronous buck circuit driver solution enable power save, once full change can continually run around 11 hours
• Battery pack is compatible with SR90 and SR91
• One key for control operation
• Rugged Indestructible aluminum body with anti-scratching type-III hard anodization. Engineered anti-slip knurling for tightly firm grip
• Deep grooves enlarge the surface area, it greatly enhances passive heat dissipation ability
• ATM( Active Thermal Management) guarantees LEDs lifetime and avoids other possible accidents caused by overheat
• Waterproof IPX-8
• MIL-SPEC.: MIL-STD-810F
• Anytime the model will keep 3 minutes running at highest brightness and then start up ATM function
• Memory function (Exclude strobe mode)
• Lock function and unlock function

Operation Introduction

No

| Name| No|

Name

---|---|---|---
1| Striking Bezel| 7| tail-cap
2| front strap ring| 8| power indicator switch
3| Head| 9| Charging Socket
4| power switch| 10| Weather-resistant plug
5| battery pack| 11| power indicators
6| rear strap ring| |

Operation Introduction

1. Power on/off the light
To power on the light, click the power switch.
To shut off the output, click the power switch
2. Switch output mode
Under on state, press and hold the power switch, the output will change between high level and low level, choose expected level then release the switch. To enter into strobe mode, double click power switch under on state.
Under strode mode, the click power switch will shut off the output, and the press and hold power switch will enter into either low level.
3. Power Indicator
Click indicator switch on tail-cap, four green indicators will approximately indicate remain energy for battery, the indicators will display 5 seconds. See below detail description:
-4 indicators full light: Full, the battery power close to full
-3 indicators light: Normal, 60-80%
-2 inductors light: Low, 40-60%
-1 Indicator light: Lower, 20-40%
-Full off: Lack, the balance power is less than 20%
4. Lock and unlock
To lock the light, under on sate, press and hold the power switch until the output shut off automatically. Under lock state, press the power switch will not power on the light. Usually, we use the lock function when we make transportation with batteries.

Operation introduction

To unlock the light, quickly click the power switch 3 times within 1 second
5.Charging
You can use a charger(included in the gift box) or car charger(optional accessory) for charge. Remove the weather-resistant plug from the end of the integrated battery pack or the whole torch, handle and plug in the barrel plug of the supplied charger. When using a charger for a charge, the red indicator will be light undercharge. If the charge is finished, the light will become green. When using a car charger for a charge, please press the indicator switch to check the power remains. If the charge finished, the four indicators will be in full light.

Usage and Maintenance

Clean contacts, threads, and o-rings with a soft clean cloth on an as-needed basis, Dirty threads and contacts are the major causes of most flashlight reliability issues. If you are regularly using your flashlight in a wet or corrosive environment be sure to clean and lubricate o-rings frequently. 0-rings are made of silicone so be sure to use a silicone safe lubricant. After any exposure to water, high ambient moisture, or corrosive environments the battery pack and tense should be removed and inspected for incursion and cleaned as needed.
For optimal performance please charge the battery pack after each use.
If the light is not used regularly be sure to charge the battery pack every 3-4 months without fail.
Failure to regularly charge the battery pack can result in premature battery pack failure.
It is advisable to never charge batteries unattended. Please charge your light or battery pack on a non-flammable surface and unplug the battery and charger upon completion of the charge cycle.
Don’t unscrew the tailcap if not necessary!
During charging the battery pack separately, or when you unscrew the battery pack and lay it aside for a long time, Please cover the battery pack with the lid to avoid unexpected short-circuiting.

Operation Accessories

Warranty

Olight m warrants its products to be free from defects in materials and workmanship. Within 30 days of receipt, any defective lights will be offered repair or replacement by the retailer where the product was purchased. Olight’Mwill repair or replace, at its option and without charge, any product or part which is found to be defective under normal use and service within 24 months counting from the date of purchasing with proof of purchase. Such repair or replacement shall be the purchaser’s sole and exclusive remedy under this warranty, This warranty does not cover normal maintenance and service and does not apply to any products or parts which have been subject to modification, misuse, negligence, accident, improper maintenance or repair by anyone other than OIightTM.
As to those exceeding 24 months of the purchase date, ()light will still provide with warranty service. Labor is free but the cost of parts will be charged. This warranty covers parts and labor only as specified above. Freight and transit costs are the responsibility of the user/owner; not the factory or dealer.

Warranty Limitation

There is no other express warranty. Olight hereby disclaims any and all implied warranties, including but not limited to fitness for a particular purpose. Olight shall not be liable for incidental, consequential, or special damages arising out of, or connection with, product use or performance.

Olight Technology Co., Limited
www.olightworld.com
Tel: +86-755-3351 8606
Fax: +86-755-3380 0207
Email: olightworld@gmail.com
www.DrMemory.com/Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>