OLIGHT Odin Turbo User Manual

USER MANUAL

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

SPECIFICATIONS

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are performed using the battery included in the light. The product obeys the IEC 60825-1:2014 standard and 21 CFR 1040.10 requirement.

Max Output: ＜0.39 mW @ 440~455nm wavelength
USB MAGNETIC CHARGING CABLE — MCC3

Maximum
charging current| 2A
Voltage of fully
charged battery| 4.2V±0.05V
Time to fully charge| 5.5 hours (For reference only. When the USB power source is
insufficient to provide 5V 2A power capacity, the charging
time will be longer)
Charge indication| Red: charging
Green: full (over 95%) or disconnected with a flashlight

PRODUCT OVERVIEW

BATTERY INSTALLATION

Before first use, unscrew the tail cap and remove the insulating film within the battery compartment before screwing the tailcap
back on tightly. If the battery needs to be replaced, make sure that the positive end of the new battery faces the flashlight head
when you put it in.

AVAILABLE BATTERIES

• 1 x customized 5000mAh 21700 rechargeable lithium battery

VIBRATING POWER INDICATOR

It helps to alert if the battery is low (power≤20%, vibrate once every 5 minutes; power≤10%, vibrate once per minute; power≤ 5%, vibrate once every 10 seconds).

• Before the first use please fully charge the product.
• Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a USB power source of no less than 10W (5V 2A) ). The red indicator means charging, while the green indicator means charging completed (battery level＞95%).
• Only charge with standard MCC3, not compatible with other MCC.

PRODUCT INSTALLATION

a. Loosen the screws and install the rail mount in its desired position, then tighten the screws.

b. Slide the product into the rail mount until you hear a click, then turn the button 90 degrees clockwise as the mark shows to fix the product. c. Rotate the button 90 degrees counterclockwise to unlock the product as the mark shows.d. Press the button and remove the product.

REMOTE SWITCH INSTALLATION

a. Attach the magnetic remote switch to the tail of the product (make sure the detent ring of the remote switch is unlocked).
b. Push the ring forward to fix the remote switch. DANGER

• DO NOT shine the light directly into human eyes. This may cause temporary blindness or permanent damage to the eyes.
• DO NOT cover the flashlight’s head or stand the flashlight on its head when it is on. The radiation energy may cause damage to the flashlight itself, or even result in the burning of flammable objects nearby.
• DO NOT use non-protected rechargeable batteries.

WARNING

• Keep out of reach of children.
• The tail switch may not work while immersed in seawater or other conductive media. Please try to keep it clean and dry.
• DO NOT disassemble the LEP module. Disassembly may result in irreversible damage.
• If the light is about to be put aside for a long time or be transported, please unscrew the tail cap and remove the battery to cut off the circuit.

NOTICE

• DO NOT short-circuit the tail switch cap with the ring surrounding it. The short circuit in this case will result in an electric discharge of below 5mA between them and may lead to a complete battery drain if it is in this state for too long.

RISK GROUP 2
CAUTION Possibly hazardous optical radiation emitted from this product. Do not stare at the operating lamp. May be harmful to the eyes.
WARNING
Complies with FDA performance standards for laser products except for conformance with IEC 60825-1 Ed. 3., as described in Laser Notice No. 56, dated May 8, 2019.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
USB magnetic charging cable: One year.
For any of the fragile or low-value fittings not covered above, like wrench and self-locking bands, you can contact the post-sale within 30 days of the purchase, if it has any quality drawback or damage under normal use conditions. If such drawback or damage occurs after 30 days of the purchase or under abnormal use conditions, we will only offer conditional quality assurance as appropriate.

USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

EU-DECLARATION OF CONFORMITY EU-Declaration of Conformity can be found here: https://olightworld.com/ec-declaration

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road,
Changan Town, Dongguan City, Guangdong, China.
Made in China

References

• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>