Litter-Robot LR3-8060 Connect Circuit Board Installation Guide

June 6, 2024
Litter-Robot

litter.robot

Litter-Robot LR3-8060 Connect Circuit Board

Litter-Robot LR3-8060 Connect Circuit Board

Upgrade Kit includes:

Kit

  • Litter-Robot Connect Circuit Board
  • Litter-Robot Connect Applique
  • QR code

INSTALLATION

You will need:

  • Needle-nose pliers
  • Flathead screwdriver or bladeInstallation-001
  1. Press the Power button to turn the Litter-Robot off and unplug it from the wall.

  2. Remove the power supply plug from the rear of the unit. Remove the bonnet and globe. Your Litter-Robot base should now look like the base in the photo.Installation-002

  3. Carefully remove the old blue applique using a small flathead screwdriver or blade.Installation-003

  4. Apply the new black applique to the control panel cover.Installation-004

  5. Remove the waste drawer from your Litter-Robot base and set it aside.

  6. Open the control panel by removing the 5 screws.Installation-005

  7. Carefully remove the circuit board cover; take care not to lose any of the screws.Installation-006

  8. Unplug the 3 connectors on the circuit board.Installation-007

  9. Before installing the new circuit board, ensure that the motor sits flush in the motor cavity and that no wires are in the way of the motor’s gear.Installation-008

  10. Remove the rubber keypad from the circuit board, setting the circuit board aside.Installation-009

  11. Install the rubber circuit board cover over the new circuit board. Make sure that it is securely fitted along all of the edges.Installation-010

  12. Connect the DFI wires to the 4-pin connector on the new circuit board.Installation-011

  13. Connect the remaining wires to the 6-pin and 8-pin connectors on the new circuit board.

  14. Replace the circuit board cover, making sure all of the buttons are in place.Installation-013

  15. Once all the connections are secured, replace the circuit board cover and secure it with the 5 screws.Installation-014

  16. Remove the old serial number label from the back of your Litter-Robot base and apply the new label from your kit in its place.
    Please note: The app will not work with the old serial number, so you must complete this step.

  17. Installation-015Reassemble the globe and bonnet. Slide the drawer into the base.Installation-016

  18. Plug the unit in. Turn the unit on, and let the initial clean cycle finish. The globe should return to the Home position with the blue Ready light on.
    Follow the Connect Quick Start Guide to onboard your Litter-Robot and connect to the app.Installation-017

Contact Customer Service
Monday – Friday, 9am – 5pm EST
1-877-250-7729 or support@litter- robot.com

References

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Litter-Robot User Manuals

Related Manuals