litter-robot UB1213 Feeder Robot Backup Battery Installation Guide
- June 5, 2024
- Litter-Robot
Table of Contents
litter-robot UB1213 Feeder Robot Backup Battery Installation
Installing the Feeder-Robot Battery
Feeder-Robot can be equipped with a backup battery (sold separately) that
provides approximately 24 hours of operation in power-saving mode if power is
interrupted.
Note:
When power is interrupted, the unit will automatically switch to battery power
and a blinking yellow light will illuminate the Power button on the Control
Panel. Feeder-Robot will switch back to household power when it returns, and
the unit will begin recharging the battery.
How to install
- Press the Power button<!) to turn the unit off, then unplug the unit.
- Gently turn the unit over to access the battery pocket on the underside of the base.
-
With the use of a Phillips screwdriver, remove the two screws at the bottom of the unit and lift up the plastic cover.
-
Connect the battery, making sure to connect the leads and terminals correctly: RED lead to the RED terminal and BLACK lead to the BLACK terminal.
-
lnsert the battery into the pocket.
-
Reinsert the plastic cover, inserting the small plastic tab first to ensure the plastic cover sits flush.
-
Attach the plastic cover using the screws provided.
-
Plug the unit back in and power it on.