litter-robot 4 Camera Mount Installation Guide
- October 30, 2023
- Litter-Robot
Table of Contents
litter-robot 4 Camera Mount
INTRODUCTION
Litter-Robot 4 can be equipped with a webcam to further monitor cats’ usage habits. Install your webcam of choice using our camera mount kit. What’s included: (1) bracket, (1) hinge, (1) ring magnet, (1) 1/4″ -20 nylon screw, (1) wire cover.
HOW TO INSTALL
-
While facing your Utter-Robot 4, hook the camera mount bracket behind the bezel as shown.
-
Snap the front of the brake forward to secure ft onto the bezel. (You will hear a snap.)
NOTE: Ensure the bracket Is positioned above (not obstructing the lasers) and is centered on the bezel. -
Mount the hinge by a careful snare; ping It onto the bracket. (This may require some force or twisting.)
You have two options for mounting your camera
- use the Included ring magnet: Add the magnet to the washer that Is attached to the hinge, and check polarity with the magnet that comes with your camera – the magnets should stick together, not repel.
- Use the Included 1/4′”·20 nylon screw.
- Mount your camera to the hinge and plug ft Into the USB port behind the control panel.
NOTE: The camera mount has many different configurations. Now would be a good time to check your desired camera angle. You can adjust the angle by flipping the hinge, flipping the side the magnet Is on, or flipping the camera. Be careful not to pinch your fingers!
-
Route the camera wire through the channel and arrange any excess wire Into a small, clean bundle as shown.
-
Place the bundle or wire In the wire cover pocket and route the wire attached to the camera end through the slot.
-
NOTE: Keep the bundle of wires as Low as possible In the wire cover pocket to avoid Interference with the bezel.
-
While keeping the wire In the wire cover pocket, snap the Wire cc,.; er onto the bracket using the slots PRC,.; led. (Be careful not to dislodge the bracket from the bezel at this step.)
-
NOTE: Ensure the wire COYer sits cleanly on the bezel. II It does not, the wire may come Loose from the wire COYer pocket and interfere with the bezel.
-
Setup complete! You are now ready to watch your kitties use Llner•Aobot 4.
Questions? Visit: whiskersupport.com.