OLIGHT Warrior X Pro Version II User Manual
- June 6, 2024
- OLIGHT
Table of Contents
USER MANUAL
Warrior X Pro
Version II
Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!
IN THE BOX
Holster
SPECIFICATIONS
All above specifications are test results based on ANSI/NEMA FL1-2009
Standard. The tests are performed using the battery included in the
flashlight.
Note: The maximum output brightness will decrease as the battery voltage
decreases.
USB MAGNETIC CHARGING CABLE — MCC3
| Parameter | Specification |
|---|---|
| Charging cable | USB type A – magnetic charge connector, length: 0.5m |
| Input | USB A – Type DC 5V 2A |
| Charging pattern | CC&CV |
| Maximum charging current | 2A |
| Voltage of fully charged battery | 4.2V±0.05V |
| Charge indication | Red: charging |
Green: full (over 95%) or disconnect with flashlight
Time to fully charge| 5.5 hours (For reference only. When the USB power supply
is insufficient to provide 5V 2A power capacity, the charging time will be
longer)
PRODUCT OVERVIEW
BATTERY INSTALLATION
Before first use, unscrew the tailcap and remove the insulating film within the battery compartment before screwing the tailcap back on tightly. If the battery needs to be changed, make sure that the positive polarity side of the battery faces toward the direction of the flashlight head (the side of the LED).
CHARGING
Vibrating Power Indicator
It helps to alert if the battery is low (power≤30% vibrate once every 5
minutes; power ≤10% vibrate once per minute; power≤ 5% vibrate once every 10
seconds).
- Before first use please fully charge the product.
- Connect the USB end of the magnetic charging cable to an external USB power source, then attach the other end of the cable to the charging port of the light (best charging efficiency with a 10W (5V 2A) USB power source). The red indicator means charging, while the green indicator means charging completed (battery level＞95%).
- Only charge with standard MCC3, not compatible with other MCC.
TGR (Tactical Grip Ring) Installation Guide
a. Unscrew the tailcap and remove the O-ring.
b. Then
remove the tactical grip ring and pocket clip.
C. Install the TGR and O-ring as shown in the picture and tighten the tailcap.
DANGER
- DO NOT throw the light directly into human eyes. This may cause temporary blindness, or permanent damage to the eyes.
- DO NOT cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to flammable objects.
- DO NOT use Non-protected rechargeable batteries.
WARNING
- Keep out of reach of children.
- DO NOT activate high mode repeatedly under high temperature to prevent the flashlight body from overheating and hurting the user’s hand.
- The tail switch may not work while immersed in sea water or other conductive media. Please try to keep it clean and dry.
- If the product is left unused or carried and transported, please loosen the tailcap a half turn to avoid accidentally activating the flashlight.
NOTICE
- DO NOT short circuit the switch cap with the ring outside it for a prolonged period. The short circuit in this case will result in a loss of current below 3mA, and may lead to a complete battery drain if it is in this state for too long.
HOW TO OPERATE
Click the tail switch lightly to produce a low light output or press the tail
switch hard to produce a high light output.
Single click (click and release quickly) the tail switch to turn the
flashlight on or off.
When you press and hold the switch, the flashlight will be in momentary mode;
when you release the tail switch, it will turn off.
EU-DECLARATION OF CONFORMITY EU-Declaration of Conformity can be found
here:
https://olightworld.com/ec-declaration
WARRANTY
Within 30 days of purchase: Contact the original seller for repair or
replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one year warranty for all rechargeable
batteries.
MCC magnetic USB charging cable: One year.
The other no warranty fragile or low-value fittings like lanyard and clip, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use condition, the conditional quality assurance will be provided as appropriate.
USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete
product line of portable illumination tools.
Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan
Town, Dongguan City, Guangdong, China.
Made in China
www.DrMemory.com/Olight
THANK YOU!
Documents / Resources
|
OLIGHT Warrior X Pro Version
II
[pdf] User Manual
OLIGHT, Warrior X Pro, Version II
---|---
References
- Olight Manual & Datasheet Library
- Olight | Illuminate Your World.
- Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>