OLIGHT M2R Pro Warrior Flashlight User Manual

M2R Pro Warrior
USER MANUAL

Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

SPECIFICATIONS

• All above specifications are test results based on ANSI/NEMA FL1-2009 Standard. The tests are performed using the battery included in the flashlight.
  Note: The maximum output brightness will decrease as the battery voltage decreases.

BATTERY INSTALLATION

Before first use, unscrew the tailcap and remove the insulating film within the battery compartment before screwing the tailcap back on tightly. If the battery needs to be changed, make sure that the positive polarity side of the battery faces toward the direction of the flashlight head ( the side of the LED ).

AVAILABLE BATTERIES

• 1 x customized 5000mAh 21700 rechargeable lithium battery

BATTERY LEVEL INDICATOR

NOTE: Under Moonlight mode, no instruction.

USB MAGNETIC CHARGING CABLE — MCC

is insufficient to provide 5V 2A power capacity, the charging time will be longer )
Charge indication| Red: charging
Green: full ( over 95% ) or disconnect with flashlight

CHARGING

• Before the first use please fully charge the product.
• Connect the magnetic USB end of the charging cable to an external USB power source, then attach the other end of the magnetic charging cable to the charging port(best charging efficiency with more than 10W ( 5V 2A ) USB power source ). The red indicator means charging, green indicator means charging completed (battery power ＞ 95%).
• Only charge with standard MCC, not compatible with other MCC.

DANGER

• Do not throw the light directly into human eyes.
  This may cause temporary blindness or permanent damage to the eyes.

• Do not cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy of the flashlight may cause damage to the flashlight itself, or even result in burning to flammable objects.

WARNING

• Do not activate turbo mode repeatedly under high temperatures to prevent the flashlight body from overheating and hurting the user’s hand.
• The tail switch may not work while immersed in seawater or other conductive media. Please try to keep it clean and dry.
• Do not use Non-protected rechargeable batteries.
• If the product is left unused or carried and transported, please lock the button to avoid accidentally activating the flashlight.

NOTICE

• When the flashlight is turned off, moonlight, low, med1, med2, or high mode will be memorized and become the default mode when the light is turned on again (high mode will only be memorized for 10 minutes. After that, the memorized mode will revert to the med1 setting).
• The flashlight has a standby current below 40µA. If the flashlight is to be put away for a long time, please loosen the tail cap by unscrewing it to cut off the current circuit and charge it before use again.
• The turbo mode will slowly step down to high mode in 4.5 minutes at a normal temperature.
• Do not short circuit the switch cap with the ring outside it for a prolonged period. The short circuit in this case will result in a loss of current below 6mA and may lead to a complete battery drain if it is in this state for too long.

HOW TO OPERATE

SIDE SWITCH
ON/OFF: Single-click the side switch to turn the light ON/OFF. When the light is turned on again, it will return to the previously memorized mode.
CHANGE BRIGHTNESS LEVEL: When the flashlight is on, press and hold the side switch and it will start from the resent brightness level, automatically cycle through low, med2, med1, and high mode. The mode is selected when the side switch has been released. ( Please note: moonlight and turbo are not in the automatic cycle ).
MOONLIGHT MODE: When the flashlight is off, press and hold the side switch for over one second to access the moonlight mode. If the memorized mode is moonlight, simply click the switch to access it.
TURBO AND RETURN fast double click on the side switch to enter into Turbo, double click again to return. If memory mode were High or Med 1, the output is Med 1; if memory mode were Med 2、low or Moonlight, the output is memory mode.
STROBE: Quickly triple-click the side switch to enter the strobe mode. To quit this mode, single click or press and hold the side switch.
LOCKOUT/UNLOCK: When the flashlight is off, press and hold the side switch ( for about 2 seconds ) to access the button lockout mode ( the flashlight will enter the moonlight mode first and will then switch off to signal the lockout mode ). Under the lockout mode, press and hold the side switch for less than one second. The red indicator below the side switch will be on for two seconds to signal that the light is still in lockout mode. To unlock it, keep holding the side switch for over one second until the moonlight mode is on again.
TAIL SWITCH
The M2R Pro produces different output settings by pressing lightly or hard on the tail switch (please refer to the following program configurations).
TWO DIFFERENT PROGRAM CONFIGURATIONS CONFIGURATION 1 (FACTORY DEFAULT SETTING) :
Half-press for Med 1, hard press for Turbo;
Single press the tail switch (press and release quickly) to turn the flashlight on or off;
Press and hold the tail switch for momentary-on. Release to turn off.
CONFIGURATION2: Half-press for Turbo, hard press for Strobe, release switch to turn the flashlight off.
SWITCH BETWEEN DIFFERENT PROGRAM CONFIGURATIONS
Switch between configuration 1 and configuration 2 by pressing hard then holding the tail switch and single press on the side switch at the same time; when you release the tail switch, the Configuration will be selected.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 5 years of purchase: Contact Olight for repair or replacement.
Battery warranty: Olight offers a one-year warranty for all rechargeable batteries.
MCC magnetic USB charging cable: 1 year The other no warranty fragile or low-value fittings like lanyard and clip, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use conditions, conditional quality assurance will be provided as appropriate.

EU- DECLARATION OF CONFORMITY

https://olightworld.com/ec-declaration

EU-Declaration of Conformity can be found here CE: https://olightworld.com /ec-declaration

USA Customer Support
cs@olightstore.com
Global Customer Support
Customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.
Made in China
D. 05, 09, 2020
3.0038.6010.9003
THANK YOU!

Documents / Resources

| OLIGHT M2R Pro Warrior Flashlight [pdf] User Manual
M2R Pro, Warrior Flashlight
---|---

References

• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>