OLIGHT Open 2 CU Copper LED Flashlight User Manual

USER MANUAL

Open 2 CU
Thank you for purchasing this Olight Product. Please read this manual carefully before use and keep it for future reference!

IN THE BOX

SPECIFICATIONS

All above specifications are test results based on ANSI/NEMA FL1-2009 Standard.

PRODUCT OVERVIEW

The product is separable; the lower part is a pen, the upper part is a flashlight, and a central blue ring is used as a separation point.

• The pen tip is protected by wax. Please remove the protective wax before writing.

CHARGING

Before first use, please fully charge the product. Unscrew the pen from the middle and store the lower part (pen). Connect the upper part to the USB power supply or computer USB port via the provided charging cable (USB power supply not included.  Users can use any USB power supply of digital devices or household appliances). The LED lights up red to indicate charging,  and the red will go out when it is fully charged. NOTE:

• Please remove the protective cap, then press and hold the tail switch to unlock the product.
• Plugin the USB cable again when it is fully charged, the charging indicator will still be Red for about 30 seconds.
• The product uses a USB-C charging interface with 4.2V 200mA constant current and voltage for charging. It can be fully charged in 55 minutes.

REFILL REPLACEMENT

a.Unscrew the tip, take out the refill and remove the spring from the refill.
Note: Please remove the spring from the refill carefully and do not stretch it.

b.Install the spring with the narrow end first on the new refill, then put the new refill back into the pen and tighten the tip.

DANGER

• DO NOT throw the light directly into human eyes. This may cause temporary blindness or permanent damage to the eyes.
• DO NOT cover the flashlight with objects, the heat generated by the flashlight may cause burning or even cause unexpected disasters.
• Keep out of reach of children. DO NOT allow children to play to prevent physical harm.

WARNING

• Beware of dropping: The refill inside is a precision assembly product, and the ball on the tip may lose its writing function if damaged.
• DO NOT soak in water: The refill of the product uses gel ink. The ink will become diluted or unable to write after being dissolved in water.

NOTICE

• When the battery level is less than 5%, the maximum output is limited to 5 lumens.
• The product adopts PWM dimming, which may cause noise when placed close to the radio.
• The clip is suitable for clamping on objects not more than 3mm thick.
• When replacing the refill, be careful not to deform the spring, as this may affect the use of the refill.
• The pure copper will develop dark copper oxide or even green rust spots on the surface when exposed to air for a long time. If not in use, please store the product in a dry environment.
•  Writing on soft or padded surfaces may result in thicker lines.

OPERATION

Used as a pen:
Gently slide the pen push button along the L-shaped track to the bottom, the tip will appear and be locked, then you can start
writing.
Release the pen push button to the top of the L-shaped track, the tip will bounce back into the pen.
Used as a flashlight:
Single-click the switch to turn the light ON (the default output is 5 lumens) / OFF.
When the flashlight is on, press and hold the switch to automatically cycle through the output.
Quickly double-click the switch to enter high mode even the flashlight is off, and quickly double-click the switch again to exit high mode.
When the light is off, press and hold the switch for one second to access the switch lockout mode. Under the lockout mode, if click the switch, the red indicator will be on to signal that the light is still in lockout mode. To unlock it, keep holding the switch
for over one second until the light is on at 5 lumens.

WARRANTY

Within 30 days of purchase: Contact the original seller for repair or replacement.
Within 2 years of purchase: Contact Olight for repair or replacement.
The other no warranty fragile or low-value fittings like refill and USB cable, you can contact post-sale in 30 days after purchase if it has quality drawback or damage under normal use condition. Over 30 days or damage under abnormal use conditions, conditional quality assurance will be provided as appropriate.

USA Customer Support
cs@olightstore.com
Global Customer Support
customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.
EU-DECLARATION OF CONFORMITY
EU-Declaration of Conformity can be found here: https://olightworld.com/ec- declaration

https://olightworld.com/ec-declaration

Dongguan Olight E-Commerce Technology Co., Ltd
4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town,
Dongguan City, Guangdong, China.
Made in China
3.1320.6010.9002
A. 10, 12, 2020

www.DrMemory.com/Olight

References

• Olight Manual & Datasheet Library
• Olight | Illuminate Your World.
• Flashlights, Tactical Light, Outdoor Tools - Olight Official Store- Olight

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>