Princeton Tec RF21-BK ReFuel LED Headlamp Instruction Manual

Princeton Tec RF21-BK ReFuel LED Headlamp Instruction Manual

Battery Installation – See Battery Installation Diagram

• 3 AAA
• Alkaline (LR03) or Lithium
• Rechargeable NiCad or NiMH

Princeton Tec cares about the environment and recommends recycling batteries. For more information about battery recycling, please go to: www.batteryrecycling.com
Open the Fuel case by popping the door latch over the catch and rotate the door open.
Install three AAA batteries according to the polarity markings on the inside of the cabinet. Observe proper battery polarity when installing the batteries. Improper installation of the batteries will damage the light and void the warranty.
Rotate the door to the closed position, squeeze the body between your forefingers and thumb to Refuel the door latch over the catch.

WARNING

• Never mix fresh and used batteries.
• Never mix different battery brands or chemistry types.
• Always remove drained batteries immediately.
• Remove batteries during long periods of storage.
  NOTE: Rechargeable NiCad or NiMH batteries may result in reduced brightness due to lower nominal voltage.

Switch Operation – See Figure 2

One Press : High
Press and Hold : Initiates dimming function. (when the LEDs reach their lowest or highest settings, the will flash once.
One Press : Off

Power Consumption

Refer to the burn time chart for performance data for different battery types and mode settings.
Princeton Tec calculates total burn time as the time it takes for the light source to produce a minimum of 0.25 lux at 2 meters. 0.25 lux is about the equivalent of a full moon on a clear night.
The times listed in this chart assume you start with fresh batteries and use only one mode.

Troubleshooting

If the Refuel fails to light:

• Check the batteries for proper installation.
• Replace batteries if proper installation is confirmed Check circuit board for water. The light will resume normal operation once the water is shaken or blown out and the light is left open until completely dry. If the light has been contaminated with salt water, flush the unit with fresh water and dry as described above.

USA– International 5-Year Warranty

WARRANTY – Princeton Tec warrants this product to be free from defects in workmanship and materials under normal use for 5 years. This warranty covers all of the component parts of the product except batteries. This warranty does not cover deterioration due to normal wear or damage due to misuse, alteration, negligence, accidents, or unauthorized repair. Princeton Tec will repair or replace parts which are defective in workmanship or materials.

Your authorized Princeton Tec Dealer and Princeton Tec are the only facilities authorized to repair the product. After (3) unsuccessful attempts (within the warranty period) to repair the product, you have the right to elect replacement of the product or a refund of the purchase price less allowance for use of the product. NO INCIDENTAL OR CONSEQUENTIAL DAMAGES ARE INCLUDED IN THIS WARRANTY. (Some states do not allow the exclusion or limitation of incidental or consequential damages, so the above limitations or exclusions may not apply to you.) This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.

Princeton Tec reserves the right to change product specifications without notice.

FOR CALIFORNIA RESIDENTS: WARNING: This product contains Bisphenol A (BpA) a chemical known to the State of California to cause birth defects or other reproductive harm.

Return Policy

If your light fails to operate, follow these simple steps:

1. Check batteries. Replace if necessary.
2. To send your light in for repair or replacement, first contact Princeton Tec customer service on 1-800-257-9080 to request an RMA number. Please have your light model, date of purchase and a brief description of the fault you are experiencing. No warranty repairs will be accepted without an RMA number.
3. Return the light without batteries to: Princeton Tec, PO Box 8057 Trenton NJ 08650. Postage due and freight collect items will not be accepted.
4. Upon receipt your light will be processed in about two weeks. Please allow additional time for return transportation from NJ

Princeton Tec
PO Box 8057,
Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2021 Princeton Tec

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>