YaberAuto YA70 Portable Car Jump Starter with Air Compressor User Manual

June 15, 2024
YaberAuto

YA70 Portable Car Jump Starter with Air Compressor
User Manual

YA70 Portable Car Jump Starter with Air Compressor

YaberAuto YA70 Portable Car Jump Starter with Air
Compressor

Know Your Product

YaberAuto YA70 Portable Car Jump Starter with Air Compressor -
parts

1 LED Screen
2 Lighting Button
3 Power Button
4 Switch Button Inflation Mode Switch/Unit Switch)
5 Air Pressure Increase Button
6 Air Pressure Reduction Button
7 UsB-C Input
8 Dc output
9 output 1
10 output 2
11 Jump-Start Port
12 LED Light
13 Air Hose Interface
14 Smart Clamp” plug
15 Red Jumper Cable (+)
16 Black Jumper Cable (-)
17 Indicator Light
18 Force Start Button

Charging Your Jump Starter

  1. Please use the included USB-C charging cable and adapter (5V/2A and above) to charge the product. (adapter is not included)
  2.  It will take about 5 hours to fully charge the unit when using a 5V/2A adapter. In order to extend the battery life, please fully charge the unit every 3 months.
  3.  When using the product for the first time, please make sure the product is fully charged.

Powering Your Devices
This portable jump starter is equipped with dual USB outputs (Output 1: 5V/2.4A Output 2: 5V/2.4A, 9V/2A, 12V/1.5A) that can quickly charge your portable electronic devices such as phones, tablets, etc.
LED Light
Short press the power button to turn on the device, then long press the lighting button more than 3 seconds to turn on the light mode, then short press the lighting button to change the light modes in lighting, SOS, Strobe. Long press the lighting button more than 3 seconds to turn off the LED light.
Air Compressor
Built-in 150 PSI air pump, it supports 5 inflation modes:  car inflation mode, motorcycle inflation mode, bicycle inflation mode, basketball inflation mode, custom inflation mode; 3 kinds of unit switching, BAR, KPA, PSI.

Inflation Modes Pressure Range
Car Inflation Mode 26-51 PSI, 1.8-3.5 Bar, 180-350 Kpa
Motorcycle Inflation Mode 26-44 PSI, 1.8-3.0 Bar, 180-300 Kpa
Bicycle Inflation Mode 30-65 PSI, 2.0-4.5 Bar, 200-450 Kpa
Basketball Inflation Mode 4-16 PSI, 0.2-1.1 Bar, 20-110 Kpa
Custom Inflation Mode 3-150 PSI, 0.2-9.9 Bar, 20-990 Kpa

How to Inflate Car Tires

  1. Take out the device and connect the air hose and tighten it, short press the power button to start the device, short press the power button ( ) again to enter the inflation mode,
  2. Short press the switch button to select the inflation mode, long press the switch button to switch 3 kinds of unit, press the “+” button / “- ” button to adjust the air pressure value,
  3.  Long press the power button to start inflation
  4. Short press the power button   or switch button , it will automatically stop inflating.

Jump Start Your Car

YaberAuto YA70 Portable Car Jump Starter with Air Compressor -
car

  1. Insert the plug of the smart clamp into the jump starter, the indicator light of the smart clamp will flash red and green alternately
  2.  Correctly clip the red and black clamps to the electrodes of the car battery (red to positive and black to negative), the indicator light of the smart clamp is always green.YaberAuto YA70 Portable Car Jump Starter with Air Compressor - car 1
  3. Start the vehicle.
  4. When the vehicle is started, remove the jumper cable from the car battery immediately.

Note:

  1. If it does not start successfully, please wait for 60 seconds and then repeat the above steps.
  2.  When using this product, please do not connect two clips together. Otherwise, this product will be damaged.

Indicator Light Troubleshooting Guide

Phenomenon of Indicator Light Method of Exclusion
The red light is always on, and the buzzer beeps shortly Please check whether

the clips are reversed, red to positive and black to negative
The red light is always on and the buzzer is always beeping| Please check whether the clips are connected together or on the same metal conductor
The red light is always on, but the buzzer does not sound| Remove the clip from the car battery and reconnect it
The red light is always on, and the buzzer beeps quickly and briefly| Smart clip failure, please contact us to replace the smart clip

Error Message on Screen/ Cause/ Solution

  • “E1 “- Low temperature charging protection: Stop charging, it will automatically release protection when the temperature rises above 2°C
  • “E2” – High temperature charging protection: Stop charging, it will automatically release protection when the temperature is lower than 45°C
  • “E3” – High temperature discharge protection: Stop charging, it will automatically release protection when the temperature is lower than 65°C
  •  “E7” – Cylinder over temperature protection: Automatically release the protection when the temperature is lower than 70°C. After the protection is released, please wait for 10 minutes before continuing to operate.

Specifications

Model YA70
USB1 Output 5V/2.4A
USB2 Output 5V/2.4A, 9V/2A, 12V/1.5A
USB-C Input 5V/2A, 9V/2A
DC Output 12V~16.8V 10A
Size 220 * 9747mm

Package Content

  • YaberAuto YA70 Jump Starter with Air Compressor *1
  • Gas Nozzles *3
  • Air Pump Hose *1
  • Smart Jumper Clamps *1
  • USB-C Charging Cable *1
  • DC Cigarette Lighter *1
  • User Manual *1
  • Portable Storage Bag *1

Maintenance

  1. Do not use the product to start an already expanded car battery.

  2. Inflate continuously for more than 10 minutes. It is recommended to stop for 10 minutes and continue to use after the temperature of the machine drops!

  3.  When using this product, keep the surroundings well ventilated, do not block the cooling
    holes, and do not use it in the following environments:
    · Damp places and places easily splashed by water.
    · A place where it is easy to drop.
    · A place subject to vibration, corrosion, dust, and chemical gas hazards.
    · A place where flammable and explosive materials are stored, and near a high- tern prelature heat source.

  4.  Check the battery level at least once every 3 months and recharge it in time.

  5.  Keep away from children and pets.

Warranty
If there is any problem or failure during use, please send your question and order number to our email.
We will provide you with good after-sales service within 24 hours.
 support@yaberauto.com

YA70 Car Jump Starter
Thank You for Choose Us

support@yaberauto.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals