Princeton Tec AXIS Rechargeable LED Headlamp Instructions
- June 6, 2024
- Princeton Tec
Table of Contents
available atBrightGuy.com
AXIS® RECHARGEABLE
LED HEADLAMP
Operating and Maintenance Instructions
(ANSI FL-1 Standard)
Runtime is defined as the duration of time from the initial light output
value—defined as 30 seconds after the point the device is first turned
on—using fresh batteries until the light output reaches 10% of the initial
value.
Reserve time is the duration of time from 10% of the initial light output
value down to 0.25 lux
Battery Charging – See Figure 1
Supplied with headlamp: Self-contained lithium rechargeable battery, micro-USB
charging cable.
Princeton Tec suggests using a charger with an output of 5V, 1A. This charger
will fully charge the battery pack in 3 to 4 hours. Slower charging will be
achieved with a charger rated with lower amperage. Some computer USB ports may
not have sufficient output to charge this or any USB rechargeable product.
Under normal usage, the supplied lithium-ion battery pack will last for
approximately 1,000
charge / discharge cycles.
- Red battery charge level LEDs indicate battery state. Red LEDs pulse when charging is in progress.
- Charging has completed when both LEDs are illuminated.
- Low Battery Indication: When the battery level reaches 25% the light will blink once indicating the charge is low.
Once the battery level drops below 20% the light will blink twice and drop to the lowest setting in the current model.
Dial functionality will be disabled to provide the maximum amount of time before the battery is completely drained and the light shuts off.
WARNING!
Do not disassemble; no user-serviceable parts.
General Care and Warnings
- Properly charge the battery to maximize its lifespan. Lithium-ion batteries do not suffer from a “memory effect,” and for battery longevity, it is preferable to charge more frequently if possible, rather than to fully deplete the battery’s charge.
- To avoid damaging your lighting system, use only chargers that meet the approved specifications.
- Axis Rechargeable is not submersible. Submerging in water will damage the lighting system and void the warranty.
- To keep your lighting system looking new, use a mild soap and water solution with a rag or sponge to periodically wipe off dirt.
Switch Operation – See Figure 1
-
A single press activates red mode at 70% output.
-
Double press activates white spot mode at 70% output.
-
Triple press activates white flood mode at 70% output.
-
In any mode, the dial is used for dimming.
– Clockwise dims to 10% output. Once the minimum is achieved, the further rotation will not do anything.
– Counterclockwise brightens to 100% output. Once the maximum is achieved, the further rotation will not do anything.
– Counterclockwise from flood mode activates dual-beam mode. -
A single press occurring more than two seconds after the previous button press will turn the light off.
-
Lockout Mode to prevent accidental activation: Can only be activated during OFF mode. To enter Lockout mode, press and hold the button for three seconds. To indicate success, two red LEDs will flash according to the battery voltage chart (see figure 2).
Troubleshooting
If the Axis Rechargeable fails to light:
- Check the charge state of the battery by either 1. Locking out the light by holding down the power button, or 2. Plugging light into a power source and observing battery charge level LEDs.
- To reset the headlamp if there are any functional errors, press and hold the button for 20 seconds.
USA– International 5-Year Warranty
WARRANTY – Princeton Tec warrants this product to be free from defects in
workmanship and materials under normal use for 5 years. This warranty covers
all of the component parts of the product except batteries. This warranty does
not cover deterioration due to normal wear or damage due to misuse,
alteration, negligence, accidents, or unauthorized repair. Princeton Tec will
repair or replace parts that are defective in workmanship or materials.
Your authorized Princeton Tec Dealer and Princeton Tec are the only facilities
authorized to repair the product. After (3) unsuccessful attempts (within the
warranty period) to repair the product, you have the right to elect
replacement of the product or a refund of the purchase price less allowance
for use of the product. NO INCIDENTAL OR CONSEQUENTIAL DAMAGES ARE INCLUDED IN
THIS WARRANTY. (Some states do not allow the exclusion or limitation of
incidental or consequential damages, so the above limitations or exclusions
may not apply to you.) This warranty gives you specific legal rights, and you
may also have other rights which vary from state to state.
Princeton Tec reserves the right to change product specifications without notice.
FOR CALIFORNIA RESIDENTS:
WARNING: This product contains Bisphenol A (BPA) a chemical known to the
State of California to cause birth defects or other reproductive harm.
Return Policy
If your light fails to operate, follow these simple steps:
-
To send your light in for repair or replacement, first, contact Princeton Tec customer service at 1-800-257-9080 to request an RMA number. Please have your light model, date of purchase, and a brief description of the fault you are experiencing. No warranty repairs will be accepted without an RMA number.
-
Return the light to:
Princeton Tec, PO Box 8057 Trenton NJ 08650.
Postage due and freight collect items will not be accepted. -
Upon receipt, your light will be processed in about two weeks. Please allow additional time for return transportation from NJ.
Princeton Tec
PO Box 8057, Trenton, NJ 08650
Phone: 609-298-9331
Fax: 609-298-9601
princetontec.com
© 2020 Princeton Tec
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>