DMP 730 3-Port Switch Installation Guide
- June 6, 2024
- DMP
Table of Contents
730 3-PORT SWITCH
Installation Guide
DESCRIPTION
The Model 730 3‑Port Switch provides a separate data network where
network‑enabled access control devices are installed.
When connected to an XR150/XR550, the 730 isolates two network ports with
IP’sprovided by the premises network.
With the use of a separate router, the DOORS network can be configured to an
entirely different IP scheme while maintaining communication with the panel.
Alarm messages are sent through the premises network to the Central Station
SCS‑1R or SCS‑VR receiver using the SCS network port of the 730.
Access control messages are only sent to a separate network of 734N or
734N‑POE AccessControl Modules through the DOORS port of the 730.
Compatibility
- XR150/XR550 Series Control Panels
- 734N Wiegand Interface Module
What Is Included?
- Model 730 3‑Port Switch
- 357‑2 Cat‑5 Cable
- Hardware pack
INSTALL THE 730
The 730 is designed to easily mount inside the panel enclosure using the standard 3‑hole mounting pattern. See Figure 2.
- Mount the plastic standoffs to the enclosure using the three included Phillips head screws.
- Insert the screws from the outside of the enclosure through the holes and into the plastic standoff that mounts on the inside of the enclosure.
- Snap the 730 onto the standoffs.
- Use 22 AWG wires to connect DC+ on the 730 to terminal 7 on the panel. Connect DC‑ to panel terminal 10.
- Connect the 357‑2 Cat 5 cable from the Network port on the panel to the PANEL port on the 730.
- Connect the premises network used for communication to the Central Station to the SCS port on the 730.
- Connect the 734N network to the DOORS port on the 730.
LED Operation
Next to each port an LED flashes to indicate active network communication.
734N NETWORK CONFIGURATION
Customer-Provided IP Address Setup
The 734N network connects to the DOORS port of the 730.
Internet The local 734N IP Address must be a unique address on the end‑user’s
network.
The Subnet Mask programming of the 734N must be the same as programmed at
Subnet Mask on the XR150/XR550.
The 734N Panel IP Address must be programmed with the address of the
XR150/XR550 local IP address.
Router-Provided IP Address Setup
All the information in Section 2 applies to this configuration.
However, with this configuration, the 734Ns receive their IPs from the router,
not from the customer’s network. his allows the 734N network to be entirely
separate from the customer’s network.
730 3-PORT SWITCH
Specifications
Power Requirements
Operating Voltage| 12 VDC
Current Draw| 80 mA
Dimensions| 5” x 3”
SCS Port| 10/100 BASE-T
DOORS Port| 10/100 BASE-T
PANEL Port| 100 BASE-T
Certifications
FCC Part 15
ETL Listed ITE Information Technology Equipment
UL 60950-1
Designed, engineered, and
manufactured in Springfield, MO
using the U.S. and global components.
LT-1280 1.01 21011
© 2021
INTRUSION • FIRE • ACCESS • NETWORKS
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
800.641.4282
DMP.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>