EGLO Bondi Ceiling Lamp with Fan – 122cm Instructions
- June 5, 2024
- EGLO
Table of Contents
EGLO Bondi Ceiling Lamp with Fan – 122cm
General Safety Information
Electrical installations may only be carried out by qualified electricians. Please note! Before proceeding with installation mains connecting cable must be de-energized (fuse turned off). Please note the following- ing symbols and safety instructions, in order to avoid damage caused by incorrect assembly or use:
- Protection class 1: Lamps with this symbol connect them on the network side with the yellow/green protective earth to the protective earth terminal
- Protection class 2: for lamps with this symbol no protective conductor necessary for safe operation.
- Protection class 3: Only operate lamps with this symbol with Safety Extra Low Voltage (SELV). Only connect to SELVcircuits.
- Minimum distance: This symbol explains the minimum distance of the illuminant to the illuminated, normally flammable surface.
- Downlights: This symbol explains that the lamp is not suitable for covering with thermal insulating material.
Changes:
Do not make any changes to the lamp or its connecting cable. Connecting
cable: The exterior flexible cable of this light cannot be repla-ced. Scrap
the lamp, if this cable is damaged. Commissioning: Do not operate the lamp if
it or its connecting cable show visible signs of damage.
Changing illuminant:
Before replacing the illuminant ensure that the light is not live! Lights and
illuminants will become hot in operation. Allow them to cool before a change.
Use only the illuminant specified on the light. The maximum power per
illuminant may not be exceeded. Also, if applicable, the prescribed illuminant
type must be observed. Care advice: Only clean lights when turned off, do not
allow any moisture into connecting areas or on current-carrying parts.
Cleaning agents can cause staining.