camry CR 7905 Air Cooler User Manual

: June 6, 2024
: camry

Table of Contents

camry CR 7905 Air Cooler
DEVICE DESCRIPTION
- DESCALING
USING THE DEVICE
CLEANING AND MAINTENANCE
TECHNICAL DATA:
Read User Manual Online (PDF format)
Download This Manual (PDF format)

camry CR 7905 Air Cooler

DEVICE DESCRIPTION

camry fig 1

Air outlet opening
Water level indicator
Wheels
Carrying handle (on both sides)
Mesh filter
Power cord holders
Water tank
Control panel

camry fig 2

SAFETY CONDITIONS. IMPORTANT INSTRUCTIONS ON SAFETY OF USE PLEASE READ CAREFULLY AND KEEP FOR FUTURE REFERENCE

The warranty conditions are different, if the device is used for commercial purpose.

Before using the product please read carefully and always comply with the following instructions. The manufacturer is not responsible for any damages due to any misuse.
The product is only to be used indoors. Do not use the product for any purpose that is not compatible with its application.
The appliacable voltage is 220-240V, ~50Hz. For safety reasons it is not appropriate to connect multiple devices to one power outlet.
Please be cautious when using around children. Do not let the children to play with the product. Do not let children or people who do not know the device to use it without supervision.
WARNING: This device may be used by children over 8 years of age and persons with reduced physical, sensory or mental capabilities, or persons without experience or knowledge of the device, only under the supervision of a person responsible for their safety, or if they were instructed on the safe use of the device and are aware of the dangers associated with its operation. Children should not play with the device. Cleaning and maintenance of the device should not be carried out by children, unless they are over 8 years of age and these activities are c arried out under supervision.
After you are finished using the product always remember to gently remove the plug from the power outlet holding the outlet with your hand. Never pull the power cable!!!
Never leave the product connected to the power source without supervision. Even when use is interrupted for a short time, turn it off from the network, unplug the power.
Never put the power cable, the plug or the whole device into the water . Never expose the product to the atmospheric conditions such as direct sun light or rain, etc.. Never use the product in humid conditions.
Periodically check the power cable condition. If the power cable is damaged the product should be turned to a professional service location to b e replaced in order to avoid hazardous situations.
Never use the product with a damaged power cable or if it was dropped or damaged in any other way or if it does not work properly. Do not try to repair the defected product yourself because it can lead to electric shock. Always turn the damaged device to a professional service location in order to repair it. All the repairs can be done only by authorized service professionals. The repair that was done incorrectly can cause hazardous situations for the user.
Never put the product on or close to the hot or warm surfaces or the kitchen appliances like the electric oven or gas burner.
Never use the product close to combustibles.
Do not let cord hang over edge of counter.
Do not immerse the motor unit in water.
Do not insert fingers or any other objects in the housing grille of the device.
Do not block the outlet.
When done, prior to putting it away, unscrew the cap at the bottom of the base to drain water from the device.
If the device is not used for a long time, unplug it from the power source.
Always use new batteries to replace the drained batteries in the remote control.
Do not move the device when the inner tank is filled with water.
Do not place any objects on the device.
The device can be used only with properly working ventilation.
To provide additional protection, it is advisable to install a residual current device (RCD) in the electric circuit with a rated residual current not exceeding 30mA. Ask an electrician for this.

Before First Use

It should be remembered that a high level of humidity may favor the development of biological organisms in the environment.
Do not get wet the device or wet the area around the device. If moisture appears, reduce the efficiency of the humidifying function.
Do not allow absorbent materials such as carpets, curtains, tablecloths to get wet.
Never leave water in the tank when the device is not in use.
During filling and cleaning, disconnect the device from the mains.
Clean the device and water tank before using it again.

WARNING: When the water is not replaced and the tank is not properly cleaned every 3 days, microorganisms that may be present in the water or in the environment where the device is used or stored may develop in the water tank and be blown out to the surroundings. This can cause a very serious health risk.
WARNING: Every three days, empty the water tank and top up with clean water. Before refilling, clean the tank with fresh tap water or using detergents. Remove any scale, deposits or film that has formed on the sides of the tank and on the interior surfaces. After washing, wipe all surfaces dry.

DESCALING

Perform the descaling procedure in accordance with the instructions of the descaling agent specified by the manufacturer.
Use descaling agents intended for this purpose.
Carry out the descaling procedure at least every 3 months.
Descaling only the water tank with the device turned off.

USING THE DEVICE

A noticeable reduction in the temperature of the outlet air occurs after putting into the water tank plastic containers attached to the product previously frozen in the freezer. It is recommended to fill the tank with cold tap water.

Place the unit on a dry, flat surface and connect to the power supply.
Pul out the water tank (7) from the back of the machine and pour in the water (Fig.B). Be careful not to exceed the maximum level.
In the CR7905 model, start the device by pressing the “ON” button on the control panel (8). In the CR7920 model, start the device using the “ON / OFF” button on the control panel (8).
The SPEED button on the control panel allows you to change the speed of the blower unit. The following speeds can be selected: HIGH (fast), MIDDLE (medium) and LOW (slow).
HUMIDIFY button lowers the temperature of the air by running the water pump. Additionally, a set of two cartridges is attached.
To use them, put them on 24 hours inside the freezer. Then add one or both of the water tank (7). To blow cool air, the device must be filled with water. When the device is operating, periodically check the water level to see whether to add water.
Pressing the SWING button starts the oscillation of vertical slats that provide even distribution of cold air stream. Horizontal slats do not move automatically, so if necessary, manually adjust them to point up or down.
The TIMER button allows for programming the amount of time during which the device will operate before turning itself off automatically (if the TIMER function is not used, the device will work until it is manually turned off).
The MODE button allows for changing the fan mode. In addition to the normal mode, you can select “NATURE” and “SLEEP.” The NATURE mode mimics the natural wind action by changing the fan speed about every 10 seconds and changing the speed from LOW through MIDDLE to HIGH. The SLEEP mode makes the device turn itself off after a specified period of time. If the speed is set to LOW, the device will turn off automatically after 30 minutes. If the speed is set to MIDDLE, after 30 minutes the device will reduce the speed to LOW and after another 30 minutes will turn off automatically. If the speed is set to HIGH, the device after 30 minutes, reduce the speed of the MIDDLE, then after another 30 minutes, reduce the speed to LOW and after another 30 minutes, turn off automatically.
The ANION button is only available on the CR7920. Press the ANION button to turn on the air ionization function. Press the ANION button again to turn off the air ionization function.
To turn off the device in the CR7905 model, press the “OFF” button on the control panel (8). To turn off the device in the CR7920 model, press the “ON / OFF” button on the control panel (8).

CLEANING AND MAINTENANCE

Clean with soft, dry cloth. Do not use chemical solvents because they can cause permanent damage or deformation of the device.
If the device is not used for three or more months, take the batteries out of the remote control.
Drain the water before storage by removing the drain plug at the bottom of the water tank. Then dry the device, mesh filter, mesh filter’s frame and housing to aviod the moisture damage.

TECHNICAL DATA:

Power source: 220-240 V ~50 Hz
Power: 60W
Power Max: 325W
Tank capacity: 8L

To protect your environment: please separate carton boxes and plastic bags and dispose them in corresponding waste bins. Used appliance should be delivered to the dedicated collecting points due to hazarsous components, which may effect the environment. Do not dispose this appliance in the common waste bin.