NEWSKILL ANUKI Wireless ANC Earbuds User Guide
- June 6, 2024
- NEWSKILL
Table of Contents
ANUKI
QUICK GUIDE
WIRELESS ANC EARBUDS
Operation function
Power on: light touch 5 seconds
Power off: light touch 5 seconds
Next song: Double touch the right earphone
Previous song : Double touch the left earphone
Volume up : Triple touch the right earphone
Volume down : Triple touch the left earphone
Answer the call : Light touch any side
Reject the call : Light touch 2 second any side
Warning
- Please do not take the earbuds apart and remodel them. otherwise, it may cause an electrical breakdown there or even completely damage the product.
- Please do not put the product under too high or too low a temperature (Below 0°C or above 45°C).
- Please avoid using the device indicator light near the eyes of children or animals.
- Please do not use the device under thunderstorms. It may cause the device to malfunction and increase the risk of electric shock.
- Please do not wipe the product with oil or other volatile liquids.
- Please do not let the device get wet with liquids.
NOTE
It may cause hearing damage under long time use, please arrange the use time
reasonably.
Charging
Earphone charging
When the earphone keeps flashing green light, it means the battery is low and
will power off soon. Please put the earphones into the charging case, it
automatically turns off and charges.
Charge case charging
When the charging case keeps flashing green light, it means the battery is low.
Please use the qualified charging cable provided by the manufacturer to charge.
The red indicator light is always on during charging; After fully charged, the
green indicator light is on for 10s then automatically goes out.
Where to see the power display?
After the earphones have connected with the phone, there is a battery mark next to the BlueTooth or earphone symbol to display the battery level.
Dual earphone mode
Method one
After fully charging, opening the cover, no need to remove the earphones will
turn on automatically, wait about 5 seconds, the red and green lights flash,
turn on Bluetooth on the phone, search for the pairing name ”ANUKI” and click
to connect.
Method two
After fully charged, take the two earphones and touch for about 5 seconds, the
red and reen lights flash, turn on Bluetooth on the phone, search for the
pairing name “ANUKI” and click to connect.
Single earphone mode
After fully charged, take one earphone and touch about 5 seconds, the red and green lights flash, turn on Bluetooth on the phone, search for the pairing name “XG-5.0” and click to connect.
How to turn on
noise reduction/transparency mode
Phone support manual setting ANC mode
How to set three modes by iPhone?
Transparent mode
When the headset is turned on or playing music, long-press left and right
about 2s on either side of the earphone, you hear a beep at the same time.
Prompt tone to enter transparent mode, Prompt tone: transparency.
Noise reduction mode
In the transparent mode, long press either side of the left and right
earphones about 2s, you hear a beep sound at the same time, Prompt tone: ANC
on
Turn off noise reduction/transparency mode
In the noise reduction mode, long press either side of the left or right for
2s, when you hear a beep, Prompt tone: ANC off
Reset Bluetooth earphone
Put the earphone into the charging case to close. Take it out after 3-5s, it will automatically re-pair!
About Signal
- Please notice the wearing method, do not cover the earphone by ear to prevent interruption of signal.
- Do not cover any earbuds on the dual earbuds mode by hand, or it will result in the interruption of signal.
- Please use this earphone under its working range (10 meters) and for best results avoid obstacles in between the connected devices.
- On the dual earbuds model, sometimes the connection of “R” may be interrupted, please check the using condition or the working range.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>