NEWSKILL Tanaris RGB Pro Gaming Table User Manual

June 6, 2024
NEWSKILL

NEWSKILL Tanaris RGB Pro Gaming Table User Manual

Installation Tips

Please don’t tighten the screws completely and go back later for a final tightening of all the screws after pieces are aligned with each other. Lacy a mat or old blanket out to assemble onto so the floor and the funiture doesn’t get scratched or damaged during building.

Part list

Accessory Kit

Step1

Lift Column          x2
Base                      x2
Leveling Studs      x6
M6x16 Screws      x8

Step2

Crossbar End Suit          x1
M6x12 Screws                x8

Step6

Socket Box                                     x1
Socket Box Fixed                           x2
Front Panel                                    x2
Headset Holder                              x1
Handset                                          x1
M6x14 Screws                               x20
M4x12 Screws                               x2
H4x4 Screws                                  x4
Tabletop Fixed Part1                      x2
Tabletop Fixed Part2                      x4
Tabletop Fixed Part3                      x3

Step7

Ready to Use

Before Plugging the table into the outlet, make sure that

– The lift columns are level and set at the lowest position.
– All the screws are tightened, to avoid the desk making noise and wobbling.

Activate the desk by following the next steps.

– Please press button down and hold for 10-15 seconds until it stutters and beeps.
– Release the button, then your desk is ready to use.

Operation Guide

  1. Memory desired height.
    -Press button “M”,display show “S-” with flash.
    -Press number and set desired position

  2. Advanced Safety feature lock and unlock the table.
    – Press button up and down at same time for 5 seconds, display “LOC”
    – All single button will be inactive and table will be unable to move.
    – Pressing button up and down together will unlock the keypad and release the LOC

  3. Reset the table
    When display show Error code or RST, Please reset the table.
    – Unplug the power cord from the control box.
    – Unplug the cable that links the keypad to the control box.
    – Wait 30 minutes and plug all the cables in again.
    – Do the reset: please press button down and hold for 10-15 seconds until it stutters and beeps.

If the keypad displays HOT, please unplug and replug and let it cool off for a couple of minutes before proceeding again.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals