SALUS RS600 Roller Shutter User Manual
- June 6, 2024
- SALUS
Table of Contents
Roller Shutter
Model: RS600
Installation Guide
531MSAL6RS112
Introduction
The Roller Shutter RS600 is part of the SALUS Smart Home system and gives you the possibility to control via the application devices which require 2 outputs with corresponding 5A switches on each output such as: Window Shutter, Motor Curtains, Lights.
Product Compliance
This product complies with the essential requirements and other relevant provisions of the following EU Directives: EMC 2014/30/EU, LVD 2014/35/EU, RED 2014/53/EU, and RoHS 2011/65/EU. Full text of the EU Declaration of Conformity is available on www.saluslegal.com 2405-2480MHz; <14dBm
Safety Information
Use in accordance with national and EU regulations. Use the device as intended, keeping it in dry condition. Product for indoor use only.
Terminal
|
Description
---|---
SL1, SL2| Relay output
L, N| 230V AC power supply
S1, S2| Input terminal to open/close the roller shutter, turn on/off light or
trigger the OneTouch rule
Wiring Diagram
Roller Shutter or Entrance Gate
Single Light Switch
Double Light Switch
Button Operation
To enter Identify Mode, short press the button. To enter Pairing Mode, press and hold the button for 3 seconds. To leave the network and perform a factory reset, press and hold the button for 10 seconds.
LED Indication
Description|
LED State
---|---
Pairing Mode| Red LED flashing quickly
No Network Connection| Red LED flashing slowly
Network Connection| Slue LED On
Identify Mode| $lue LED flashing quickly
Network Connection but loss link| $lue LED flashing slowly
Pairing
Now you can continue the setup and configure your device as a Roller Shutter, Single Light Switch, or Double Light Switch. Follow the steps below in order to complete the setup.
If you wire your device for Roller Shutter or Entrance Gate (see Wiring Diagram 1), do not configure it as a Double Light Switch in the app, as this will result in permanent damage to your roller motor.
UK: tech@salus-tech.com
tel: +44 (0) 1226 323961
DE / NL: support@salus-controls.de
tel: +49 6108 8258515
FR:
technicalsupport@saluscontrols.fr
tel: +33 (0) 134 724 039
IMPORTER:
QL CONTROLS Sp. z o.o. Sp. k.
ul. Rolna 4, 43-262 Kobielice
PRODUCER:
Salus Limited
6/F, Building 20E, Phase 3,
Hong Kong Science
Park, 20 Science Park East Avenue,
Shatin, New Territories, Hong Kon
SALUS Controls is a member of the Computime Group.
Maintaining a policy of continuous product development SALUS Controls plc
reserves the right to change specification, design, and materials of products
listed in this brochure without prior notice.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>