MarCum TECHNOLOGIES B00W6H1DME Wireless Camera Panner User Manual

MarCum TECHNOLOGIES B00W6H1DME Wireless Camera Panner User Manual

Charging instruction:

1. When the panner is charging, the LED light will be pulsing slowly.
2. When it has fully charged, the LED light will stop pulsing and always be off.
3. If the charger is disconnected during the charging process, the panner will be turned off automatically.
4. When the panner is working, a steady LED light means a fully charged battery. If the light is flickering in a pattern, the number of flickers indicates the battery strength out of a possible 4 levels. [Example: the light flickering in a repeating pattern of 2 indicates battery strength is 2 out of 4]
5. The LED light flickering very quickly indicates the battery does not have sufficient power.

Wireless Panner Specs

Work frequency: 315mHZ
Working voltage:3.7V
Receiving sensitivity: -105bBM
Distance:< 10m
Stand-by current: 10mA
Rotate speed: 12 RPM
Charging power: 5V/500mA
Power consumption: 0.2W
Battery: 3.7V/2200mA
Working temp:-15—+65
Storage temp:-20—+70
Dimension 227mm62.550mm

Diagram of features:

A: Power button [on panner] B: LED light [on panner] C: Left control button: pans to the left [on remote] D: Right control button: pans to the right [on remote] E: Charging port [on panner]

Operation:

Deploy the camera:

Lower your camera to the desired depth, then
position the cable in the u-shaped channel on the bottom of the panner. Use the retainer clip to anchor
the camera cable in place. Open the legs of the panner and position it above the hole in the ice.

Turn on and operate the panner:

Press and hold the power button (A) about 3-4 seconds until the light is on. Press the C or D button to pan left or right.

Turn off the panner:

Press and hold the power button (A) for about 3-4 seconds until the light is off.

TROUBLE SHOOTING:

Pairing:

Turn on the wireless panner, and quickly press the power button (A) 3 times in 3 seconds.
Next, press and hold either button(C or D) on the remote until the motor is rotating to left or right. This means that the pairing is OK, and the wireless panner can be controlled by this remote.

Using a new remote:

If the remote is lost, you first must order a new remote. Once you have a new remote:
Step 1: Turn on the wireless panner, and quickly press the power button (A) 6 times in 6 seconds, the
LED light will turn off automatically in 10 seconds.
Step 2: Turn the wireless panner back on and quickly press the power button (A) 3 times in 3 seconds;
Step 3: Press and hold either button(C or D) of the new remote until the motor is rotating to left or right. This means that the pairing is OK, and the wireless panner can be controlled by this remote.

Read More About This Manual & Download PDF:

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>