HYPERCEL 15524 Cobra Strike True Wireless Gaming Earbuds User Manual
- June 6, 2024
- HYPERCEL
Table of Contents
PRO GAMING SERIES
COBRA STRIKE
TRUE WIRELESS GAMING EARBUDS
User Manual
SPECIFICATIONS
- LED Indicators
- USB-C Input
- 1ft/30cm
- 3x Ear Gels
HyperGear CobraStrike True Wireless Gaming Earbuds
Model: 15524
FCC ID: 2AQSC-15524
INSTRUCTIONS
Fully charge your case and earbuds before first use.
- Place the earbuds in the charging case and close the lid.
- Use the included USB-C cable to connect the case to a USB power source.
Charging the Case
Charging the Earbuds (between Uses)
NOTE: While charging the earbuds, the LED lights on the case will be solid BLUE and will turn off when charging is complete.
Power On
Encender
Allumer
Option 1: Remove the earbuds from the charging case. They will turn on
automatically.
Option 2: Touch the Touch Control Sensor on BOTH earbuds at the same time for
5 seconds.
Power Off
Apagar
Eteindre
Place the earbuds in the charging case and close the lid. They will turn off
automatically.
How to Pair.
-
Remove the earbuds from the charging case. They will turn on automatically and pair with each other while the right earbud’s BLUE/RED LED flashes.
NOTE: If the earbuds do not connect to each other after powering on, tap the touch control sensor on each earbud twice, at the same time. -
Activate the Bluetooth feature on your device (phone, tablet, etc.) and select “HYGCobraStrike” to connect and pair.
NOTE: If your device prompts for a PIN code, enter “0000”
NOTE: The earbuds will automatically reconnect to the last paired
Bluetooth audio device when the unit is turned on.
Audio Controls
Play/Pause| Tuch
(R or L) Earbud
---|---
Previous Track| Touch 2x
(L) Left Earbud
Next Track| Touch 2x
(R) Right Earbud
Game Mode On/Off| Tuch 3x
(R or L) Earbud
Note: You will hear the voice prompt “Game Mode” and the LEDs in the earbuds will be breathing, or you will hear “Normal Mode” for music listening.
Call Controles
Answer| Touch
(R or L) Earbud
---|---
Hang Up| Touch
(R or L) Earbud
Reject Call| Touch & Hold (2 Sec)
(R or L) Earbud
- Functions may vary depending on phone models
Contact info@myhypergear.com to submit a
warranty claim.
Proof of purchase is required.
Need help? Visit www.myhypergear.com for additional product information or email info@myhypergear.com
IMPORTANT
Read all safety instructions and warnings prior to using this product. Improper use and failure to follow safety guidelines could result in damage, excess heat, toxic fumes, fire, explosion, electrical shock, or other hazards causing serious and/or fatal injury and/or property damage and not the manufacturer’s responsibility. The user is responsible for maintaining this product with care for maximum use.
- Do not store the device in a depleted state. Battery cells may be damaged. Charge your unit at least once every 3 months even when not in use.
- Always store the earbuds in the case when not in use.
- Permanent hearing loss may occur if you listen to high volumes. Set the volume to a safe level.
- Do not store at extreme temperatures (below 40°F or above 90°F)
- Recharge your device with the included USB-C charging cable or a certified 3rd party cable and a 2A charging adapter. Standard cables and adapters may charge the battery too slowly and damage/overheat the battery or cause a fire hazard.
- Do not attempt to modify, disassemble, or repair this product.
- Avoid excessive drops, bumps, and abrasions. If the device has dents, punctures, tears, deformities, or corrosion, discontinue use and contact the manufacturer or dispose of it in an appropriate method.
- If you find this product rapidly increasing in temperature, emitting an odor, deformed, abraded, or demonstrating an abnormal phenomenon, discontinue use immediately.
- Disposal of the unit in the garbage is unlawful under state and federal environmental laws and regulations.
FCC Warning
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Radiation Exposure Statement
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>