HYPERCEL 14659 Solar 10000mAh Wireless Power Bank User Manual
- June 6, 2024
- HYPERCEL
Table of Contents
HYPERCEL 14659 Solar 10000mAh Wireless Power Bank
IMPORTANT
NOTE : This charger is designed for Qi-compatible devices. If your
phone does not have built-in Qi wireless charging capabilities, please use a
certified Qi wireless charging case or receiver. Refer to your phone’s user
manual for detailed features and functions.
Phone cases that contain metal, magnets, or are thicker than 3mm will interfere with wireless charging.
SPECIFICATIONS
Input
Micro USB SV/ 2.l A
USB-C SV/2 .lA
Output
Total 5V/2.4A (shared)
Qi 5V/lA
USB 5V/2.lA
USB-C 5V/2.lA
NOTE: Total Output is 2.4A. When charging 3 devices, this output will be shared
PARTS LIST
- Power Button
- Protective Flap
- Micro USB Input
- USB Output
- USB-C IN/OUT
- Wireless Charging Surface
- Anti-Slip Grip
- Wireless Charging Indicator
- Solar Panel
- Solar Charging Indicator
- Battery Level Indicator
- Carabiner Ring
- Dual LED Flashlight
- Carabiner Strap optional
- Compass
INSTRUCTIONS
Fully Charge before first use Recharging via Micro USB or USB-C
Connect to a USB power source using the included Micro USB charging cable or a
certified 3rd party Micro USB or USB-C cable and a 2A charger. Once plugged
in, the power indicators will flash. The LEDs will turn solid when the battery
is fully charged (approximately 6 hours)
NOTE: When recharging via Micro USB or USB-C, the power bank cannot charge connected devices
Recharging via Solar Panel
NOTE: Solar charging is intended for emergency use only.
Position the battery for maximum sun exposure. It will immediately start charging and the Solar LED indicator will turn GREEN. It wi ll take approximately 67 hours to fully charge the battery in direct sunlight.
NOTE: When recharging via solar panel, the battery can simultaneously charge connected devices. However, overall charging time will increase if solar power is being shared between devices and the battery itself.
CHARGING YOUR MOBILE DEVICE
WIRELESS
Press the Power button . The Wireless Charging Indicator will turn GREEN
Place your phone on the designated charging area. Your phone will indicate
when charging begins.
It’s normal for a wireless charger and your device to become warm while charging.
USB
Connect your device to the USB or USB-C port using the charging cable that
came with your mobile device or a certified 3rd party charging cable. Your
device will immediately start charging
NOTE: Keep your mobile devices (phones, tablets, etc.) out of direct sunlight. Excessive heat may cause damage.
IMPORTANT
Read all safety instructions and warnings prior to using this product.
Improper use and failure to follow safety guidelines could result in damage,
excess heat, toxic fumes, fire, explosion, electrical shock or other hazards
causing serious and/or fatal injury and/or property damage that is not the
manufacturer’s responsibility. The user is responsible for maintaining this
product with care for maximum use.
- Recharge the unit with the included Micro USBcharging cable or a certified 3rd party Micro USB or USB-C cable and a 2A charging adapter. Standard cables and adapters may charge the battery too slowly and damage/overheat the battery or cause a fire hazard. Solar charging is intended for emergency use only.
- Do not store in a depleted state. Battery cells may be damaged. Charge your unit at least once every 3 months even when not in use
- Do not store at extreme temperatures (below 40 ° For above 90 ° F). Battery cells may be damaged
- Do not attempt to modify, disassemble, or repair this product
- Avoid excessive drops, bumps, and abrasions
- If the device has dents, punctures, tears, deformities, or corrosion, discontinue use and contact the manufacturer or dispose of in an appropriate method.
- If you find this product rapidly increasing in temperature, emitting odor, deformed, abraded, or demonstrating an abnormal phenomenon, discontinue use immediately.
- Do not use in the vicinity of flammable liquids or gases, propane tanks, large engines, high voltage devices, or heat sources such as radiators and
- If the Protective Flap is not properly closed, the battery will not be properly sealed and fully water Do not expose to corrosive materials. Do not clean with harsh chemicals, soaps or detergents.
- Disposal of the unit in the garbage is unlawful under state and federal environmental laws and regulations.
Contact info@myhy pergear.comto submit a warranty claim. Proof of purchase is required.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
To maintain compliance with FCC’s RF Exposure guidelines. This equipment should be installed and operated with minimum distance between 20cm the radiator your body: Use only the supplied antenna.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>