ROCKVILLE RG212CA V2 Wiring Diagram Instruction Manual
- June 6, 2024
- RockVille
Table of Contents
ROCKVILLE RG212CA V2 Wiring Diagram
FEATURES
- Bass Remote port: connect the included dash-mounted remote via RJ11 cable (included).
- High Level inputs: these inputs, also referred to as speaker level inputs, allow you to connect to the factory speaker wires. They are called High Level inputs because they convert the high voltage running through the factory speaker wires to a voltage the amplifier can handle. These inputs will provide the end user with clean, well defined sound for optimal musical enjoyment.
- RCA inputs: connect directly to your head unit’s RCA ouputs.
- Level control: The level control regulates the volume input to the pre-amp stage.
- LPF control: Adjust Low Pass frequency from 50Hz – 200Hz.
- Power connections: See wiring diagram below for proper set up.
- Fuse
- Power/Protect LED indicators.
WIRING
ATTENTION: The ground wire should be 8 gauge or heavier. Ensure that there is no paint or other insulator at the point of contact on the chassis.
WARNING: Do not use Remote Turn-on (REM) when using High Level inputs.
RG212CA V2 WIRING GUIDE
HIGH LEVEL INPUT
(WARNING: Use either High Level inputs or RCA inputs. NEVER USE BOTH!
(WARNING: Do not use Remote Turn-on (REM) when using High Level inputs.
RCA INPUT
ATTENTION: If your Head Unit has an RCA subwoofer output, use a single
RCA to dual RCA cable.
WARNING: Use either High Level inputs or RCA inputs. NEVER USE BOTH!
©2021 ROCKVILLE// The information presented is subject to change and/or improvement without notice.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>