ELECOM M-CCP1BB Bluetooth Mouse Ultimate BlueLED Silent Clippable Mouse User Manual
- June 6, 2024
- ELECOM
Table of Contents
M-CCP1BB Bluetooth Mouse Ultimate BlueLED Silent Clippable Mouse
****
****
****
****
or
****
****
****
⊆
, ****
Model: M-CCP1BB
Mouse Assistant
elecomus.com/web/mouse-assistant/
Download “ELECOM Mouse Assistant” from the ELECOM website to use its button
assignment and high-speed scrolling functions.
https://elecomus.com/web/mouse-assistant/
Manual
Wireless Mouse
Name and function of each part
-
Left button
-
Right button
-
Tilt wheel
You can scroll horizontally by tilting the wheel to the left or right.
To use the horizontal scroll function on
Windows®, ELECOM Mouse Assistant must be installed. -
The “Back” button
Operates the “Back” button on the Web browser.
To use the “Back” button on your Macintosh, it is necessary to install the “ELECOM Mouse Assistant”. -
LED light
• During the pairing standby state, the LED blinks green.
• Turns on in red when charging.
• Turns on in green for a fixed period of time when the power is turned on. When the remaining battery becomes low during use, the LED blinks red. -
Connector cover
-
Micro USB connector for charging
-
Pairing button
-
Power Switch
-
Optical sensor
- Please note that looking directly into the sensor light may hurt your eyes.
11. Clip
Clip it to your bag, breast pocket, laptop, etc. - When clipping the mouse to your laptop, please be careful not to scratch the casing or the LCD screen of your laptop.
Charging
-
Open the connector cover.
-
Connect the USB [micro-B] connector of the included USB charger cable to the charging micro USB connector of the product.
-
Connect the USB [A] connector of the USB charger cable to the USB port on a PC.
Be sure to sufficiently check the connector orientation and the insertion location. -
If the PC is not on, turn it on.
The LED light turns on in red, and charging begins.
When charging is finished, this light will turn off.
If the LED lamp does not stop blinking even after the prescribed charging time (approximately 3.5 hours), remove the charging USB cable and stop charging for the moment. Otherwise, this can cause heating, explosions, or fires.
Turning the Power On
- Slide the power switch to the ON position (the green side).
The LED light is lit green for a fixed time.
- When the remaining battery is low, the LED blinks red for a fixed time.
Power-saving mode
When the mouse is left untouched for a fixed period of time while the power is ON, it automatically shifts to power-saving mode. The mouse is released from the power-saving mode when it is touched. - Mouse operation may be unstable for a few seconds after returning from the power-saving mode.
Pairing with a PC
- Pairing involves registering Bluetooth ® devices (in this case, this product and your device) with each other, and authorizing a connection between them.
- This section covers Windows® and Macintosh standard Bluetooth ® functions. Depending on your device or Bluetooth ® adaptor, unique Bluetooth® functions may be used. Please read the respective manuals for each function.
- Please carry out the pairing operation using your current mouse or touchpad on your device.
Windows® 10
-
Click on the “Start” button on the lower left of the screen, and click on the “Settings” icon.
-
Click on “Devices” on the “Settings” screen.
The “Devices” page will appear.
-
Click on “Bluetooth & other devices”, and click on “Add Bluetooth or another device”.
-
Click on “Bluetooth”.
|
---|--- -
When the “Add a device” window appears, use a pointed item to press the pairing button of the device for 2 to 3 seconds, and then release.
Pairing mode is activated, and the LED light blinks green.
-
Click on “CAPCLIP PRO” to start pairing.
-
When it changes to “Connected”, click on “Done”.
-
This product is added to “Mouse, keyboard, & pen”, displays “Connected “ and pairing is complete.
macOS Catalina (10.15)
-
From the Apple menu, click “System Preferences…” to display the system environment settings screen.
-
Click “Bluetooth” to display the “Bluetooth” environment settings screen.
-
When searching for the device, use a pointed item to press the pairing button at the bottom of the device for 2 to 3 seconds, and then release.
Pairing mode is activated, and the LED light blinks green.
-
Select “CAPCLIP PRO”, and click “Connect” to start pairing.
-
Pairing is complete when the “Connected” pops up on the screen, and the status of the “CAPCLIP PRO” is “Connected”.
When keyboard setup assistant appears
Depending on the environment, ”Keyboard Setup Assistant” may appear.
In this case, click the “Close” button on the top left to end “Keyboard Setup Assistant”. There is no issue here.
When using the mouse
- Attach the cap to the rubber at the back end of the mouse before use.
Storing the mouse
-
Insert the mouse into the cap to store it.
-
.You can clip it to your bag, breast pocket, or PC and carry it around.
Specifications
Supported OS| Windows° 10, Windows° 8.1, macOS Catalina(10.15),
i0S13.5/iPadOS13.5, Android OS 7 to 10
(Updating the OS or installing a service pack may be necessary.)
- Compatibility information was retrieved during operation confirmation in our verification environment. There is no guarantee of complete compatibility with all devices, OS versions, and applications.
---|---
Resolution| 1600 dpi
Compatible standard| Bluetooth 5.0 Class2
Profile| HOGP (HID Over GATT Profile)
Radiofrequency| 2.4 GHz band
Radio wave method| GFSK
Radio wave range| Magnetic surfaces (such as steel desks): approximately 3 m
Non-magnetic surfaces (such as wooden desks): approximately 10 m
These are test values in the company environment and are not guaranteed.
Dimensions
(W x D x H)| When in use:
Approximately 1.7″ x 4″ x 1.38″ When stored:
Approximately 1.7″ x 2.5″ x 1.38″
---|---
Weight| Approximately 0.14Ib
Including the battery
Operational temperature/humidity| 41°F to 104°F/ up to 90%RH (without condensation)
Storage temperature/ humidity| 14°F to 140°F/ up to 90%RH (without condensation)
Battery| Built-in lithium-ion rechargeable battery (the battery cannot be moved or replaced)
Operating time| Guidelines when used with a fully charged battery
Continuous operation time: Approx. 14 hours Continuous standby time: Approx. 26 days Estimated usage time: Approx. 24 days (The usage time is estimated given a mouse operation percentage of 5% of the 8 hours per day spent operating a PC.)
Safety Precautions
Prohibited action
Mandatory action
The situation that needs attention
DANGER
Please use the included charging cable, and perform the charging operation as
directed by ELECOM.
Using a charging cable other than the one provided, or not properly following
the charging operation directions, may result in overheating, leakage, or
explosion.
Do not tamper with or attempt to take apart the product.
This may result in re or electric shock.
Do not use this product if it is leaking.
If the internal battery is leaking, immediately stop the use of the product.
This can pose a risk of overheating and/or damage.
Immediately stop using this product if you notice anything unusual.
Do not use this product if you notice a leaking battery, odd color changes,
warping, or any other abnormalities. Continuing to use the product under these
conditions may result in overheating or explosion.
If a liquid substance from this product comes into contact with any part of
your body or clothing, immediately use and wash the contacted area with clean
water.
Contact between your skin and any liquid inside the internal battery may
result in skin damage.
Only use this product at the specified rated voltage.
Using this product outside of the specified rated voltage range may result in
overheating, electric shock, or injury.
WARNING
In the case that liquid from the internal battery enters your eyes, do not
rub, as this may cause loss of vision. Immediately ush the contacted area with
clean water and seek treatment from a physician as soon as possible.
If a foreign object (water, metal chip, etc.) enters the product, immediately
stop using the product, and then turn the product off. Continuing to use the
product under
these conditions may cause a re or electric shock.
If an abnormality is found with this product (such as smoke or an unexpected
smell from the product), immediately stop using it and turn the power off.
When charging, disconnect the included cable from the USB power supply, such
as a USB AC adapter.
After doing this, contact the retailer from whom you purchased the product.
Do not drop or hit this product.
If this product is damaged, immediately stop using the product and turn the
mouse body off.
If you continue to use the product under these conditions, it may cause are or
electric shock.
Do not attempt to disassemble, modify or repair this product by yourself, as
this may cause are electric shock or product damage.
If you continue to use the product under these conditions, it may cause are or
electric shock.
Do not put this product in re, as the product may burst, resulting in are or
injury.
CAUTION
Do not place this product in any of the following environments:
- In a car exposed to sunlight, a place exposed to direct sunlight, or a place that becomes hot (around a heater, etc.)
- In a moist place or a place where condensation may occur
- In an uneven place or a place exposed to vibration
- In a place where a magnetic eld is generated (near a magnet, etc.)
- In a dusty place
This product does not have a waterproof structure. Use and store this product
in a place where the product body will not be splashed with water or other
liquids.
Rain, water mist, juice, coffee, steam, or sweat may also cause product
damage.
Do not look directly at the light from the optical sensor.
Doing so may lead to eye damage.
Only use this mouse with PCs and video game systems.
Do not use this product with any device that may significantly be affected if
the product were to malfunction.
If this product is used on a transparent surface, such as glass, or a highly
reactive surface, such as a mirror, the optical sensor will not function
correctly and mouse cursor movement will become unstable.
When you no longer need to use this product and the battery, be sure to
dispose of it in accordance with the local ordinances and laws of your area.
Cautions for Wireless Equipment
This product is wireless equipment using the entire range of the 2.4 GHz band
and it is possible to avoid the band of mobile object identification systems.
GFSK is used for the
radio wave method. The interference distance is 10 m. The 2.4 GHz band is also
used by medical equipment, Bluetooth, and wireless LAN equipment conforming to
the IEEE802.11b/11g/11n standard.
- Before using this product, check that there are no other “radio stations”* operating nearby.
- If electromagnetic interference occurs between this product and other “radio stations”, move this product to another location or stop using this product.
- Other “radio stations” refer to industrial, scientific, and medical devices using the 2.4 GHz band, as this product does, other radio stations of this type, licensed radio station premises for a mobile object identification system that is used in factory production lines, certain non-licensed low power radio stations and amateur radio stations.
WARNING
-
Do not use this product with a device that may have a serious function or inuence. There are rare cases where an external radio wave at the same frequency or the radio
wave emitted from a mobile phone causes this product to malfunction, slow down or fail to operate. -
Do not use this product in a hospital or other locations where the use of radio waves is prohibited. The radio waves of this product may affect electronic and medical
devices (e.g. pacemakers). -
The use of a wireless mouse in an aircraft is prohibited by aviation law because doing so may interfere with night safety. Turn off the power of the mouse body before
boarding an aircraft and do not use it in the aircraft. -
ELECOM is not liable for any accident or any indirect or consequential damage incurred due to the failure of this product.
Limitation of Liability
In no event will ELECOM Co., Ltd be liable for any lost profits or special,
consequential, indirect, punitive damages arising out of the use of this
product.
ELECOM Co., Ltd will have no liability for any loss of data, damages, or any
other problems that may occur to any devices connected to this product.
FCC ID:
YWO-M-CCP1BB
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE; This equipment has been tested and found to comply with the limits
for a Class B Digital Device, pursuant to part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instruction, may cause harmful interference to radio
communication. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna
– Increase the separation between the equipment and receiver
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected
– Consult the dealer or an experienced radio/TV technician for help
NOTICE: The manufacture is not responsible for any radio or TV interference caused by unauthorized modifiation of this equipment. Such modifications could void the user’s authority to operate the equipment. In order to make improvements to this product, the design and specifications are subject to change without prior notice.
CONTACT
US
elecom.net
|
FOLLOW US
facebook.com/elecomus
---|---
- Unauthorized copying and/or reproducing of all or part of this manual is prohibited.
- The specifications and appearance of this product may be changed without prior notice for product improvement purposes.
- When exporting this product, check the export regulations for the country of origin.
- The Bluetooth ® word mark and logos are registered trademarks owned by Bluetooth SIG, Inc., and any use of such marks by ELECOM CO., LTD. is under license.
- Windows is a trademark of the Microsoft Corporation.
- macOS Catalina, Macintosh, and iPad OS are trademarks of Apple Inc., registered in the U.S. and other countries.
- Company names, product names, and other names in this manual are either trademarks or registered trademarks.
A customer who purchases outside Japan should contact the local retailer in
the country of purchase for inquiries.
In “ELECOM CO., LTD. (Japan)”, no customer support is available for inquiries
about purchases or usage in/from any countries other than Japan. Also, no
foreign language other than Japanese is available. Replacements willbe made
under the stipulation of the Elecom warranty, but are not available from
outside of Japan.
Wireless Mouse
Manual, Safety precautions, and Compliance with regulations
1st edition, November 30, 2020
©2020 ELECOM Co., Ltd. All Rights Reserved.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>