SilverStone FARA V1 User Manual

SilverStone FARA V1

FARA V1
Premium case with substantial airflow, durability and compatibility

www.silverstonetek.com

Installation instructions based on this model: SST-FAV1MB-PRO

Accessory Content

SSD RUBBER PAD Mounting for 2.5” SSD, motherboard

STANDOFF Motherboard support

SCW-632-5-∮7-I-HEAD -CROSS-BK
HDD screws

BUNCH WIRE TAPS Bunch wire taps for cable management

STANDOFF SOCKET WRENCH
Install standoff

SCW-632-5-∮7-I-HEAD -CROSS-BK
Mounting for 2.5” SSD, motherboard

STEP SCREWS Mounting for 2.5” SSD

SCW-632*6-HEX-HEAD

• WASHER-TRILOBULAR
• BK
  Mounting for PSU, Graphics card, 3.5″ HDD

WARRANTY CARD

Installation Guide

1. Remove the screws
2. Remove side panels

PSU Installation

1. Install PSU
2. Secure PSU with screws

Motherboard Installation

1. Install rear I/O shield
2. Use the standoff socket wrench to secure mother-board standoff
3. Install motherboard
4. Secure the screws

Graphics Card Installation

1. Remove expansion slot holder and slot cover
2. Secure graphics card and expansion slot holder

Storage Device Installation

1. Remove the bottom 2 HDD cage screws
   A. Install 2.5” SSD on top of the cage
   B. Or install 3.5” HDD on top of the cage

2. Install 3.5” HDD

3. Please select the position (1 or 2) you wish to secure the HDD drive cage

4. Secure HDD cage

2.5” SSD Installation (Motherboard Tray)

1. Secure SSD rubber pads and screws
2. Align SSD to the mounting hole, then secure by sliding into the smaller mounting hole side.

ARGB Lighting Connection

1. Connect light strip to PSU
2. Connect the light strip’s signal control cable to 2 or 3 *Please ignore step 3 if you do not wish to connect to motherboard for synchronization

Installation Complete

Reinstall side panel and secure screws

Component Restrictions

1. Cooler height limit is 163mm, cooler is allowed to protrude the edge of motherboard by 26mm
2. Graphics card length limit is 378mm (not including the thickness of the front fans), width limit is 168mm
3. PSU maximum depth limit is 206mm
4. Installing radiator on the top panel
   RAM maximum height limit is 34mm, maximum height for other motherboard component is 37mm Installing radiator at the front panel and fans’ maximum thickness limit is 53mm
   SSD must be installed first if installing a 140/mm280mm radiator at the front with maximum thickness of 7mm

Optional Installation

Fans Support
F：120mmx2/140mmx2
T：120mmx2/140mmx2
R：120mmx1

Radiator Support
F：120mm/140mm/240mm/280mm T：120mm/240mm
R：120mm

Please remove the front panel first when installing fans or radiator at the front.

SilverStone Technology Co. Ltd
www.silverstonetek.com
Support@silverstonetek.com

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>