veho VHS-006-OS Cave Wireless Siren User Guide
- June 6, 2024
- veho
Table of Contents
wireless siren
VHS-006-OS
User Guide
Introduction to the Cave Wireless Siren
The Cave Wireless Siren comes with everything you need to add to your existing Cave system. Installation is simple and does not require a professional electrician.
Step 1 Deactivate the Anti-Tamper Button
Lay the Cave Wireless Siren on a flat surface, ensuring the ‘Anti-Tamper Button’ on the back of the siren is not activated during installation.
Step 2 Insert the batteries
Remove the front casing from the siren and open the silicone flap to expose
the power input ports. Insert 3 x D batteries (not included) and switch the
‘ON/OFF’ to ‘ON’.
Warning! Once the batteries are inserted the siren will trigger if the ‘Anti-
Tamper Button’ is activated. To stop this from happening the ‘Anti-Tamper
Button’ will need to be depressed throughout the installation.
Step 3 Adding the siren to the Cave app
On the home screen select ‘Add Accessory’ and click on ‘Learn Mode’. ‘Add Accessory’ is also on the System Setting’ page.
Step 4 Start learning
From the dropdown list select the ‘Wireless Siren’ and click ‘Start Learning’. Follow the on-screen instructions for pairing and naming the accessory. The new accessory will be saved under ‘Accessories Management’.
Step 5 Mounting the siren
Tools required Power drill and screwdriver.
When mounting the siren ensure it is positioned out of reach to prevent
tampering. Using the siren backplate as a template mark out and check mounting
positions before drilling the holes. When inserting the screws leave enough
visible to hang the siren from. Only use a ladder if you are competent using
one, otherwise, seek professional assistance.
Siren settings
Under ‘Accessories Management’ go to ‘Wireless Siren’ and select ‘Siren
Settings’. Within the settings, you can adjust the following.
Light Mode Adjusts when the siren lights flash i.e. lights flash to show the
siren is set to ‘Arm’ to act as a deterrent.
Prompt Tone Sets when the siren should beep i.e. the siren should beep when
set to ‘Armor ‘Disarm’.
Prompt Volume Sets the sound level of the ‘Prompt Tones’ to either low,
medium, high or mute.
Alarm Volume Sets the sound level of the siren to either low, medium, high or
mute.
Siren Duration Sets the duration the siren should sound for once activated,
choose between 1 to 5 minutes.
Test Button Confirms the connection between the app and the siren, press once
and the siren will beep twice if connected.
DISCLAIMER:
Veho is not responsible for ensuring your Cave Wireless Siren is operating
correctly. Any loss of possessions or damage to property whilst using the Cave
system is the responsibility of the user. Please ensure your Cave Wireless
Siren is installed correctly, and you are familiar with operating the Cave app
before using it.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>