munchkin 21330 Bluetooth Enabled Baby Swing Owner’s Manual

: June 6, 2024
: munchkin

munchkin 21330 Bluetooth Enabled Baby Swing

IMPORTANT SAFEGUARDS

Important Safeguards

WARNING: To prevent serious injury or death from infants falling or being strangled in straps:

Always secure infant in the restraint system provided.
Never leave infant unattended in swing.
Discontinue use of swing when infant attempts to climb out (approximately 9 months).
Always place swing on floor. Never use on any elevated surface
Maximum weight 20 lbs (9 kg).
Check this product regularly and contact Munchkin for replacement parts and instruction if needed. Never substitute parts.
Power adapter cable: strangulation hazard! Keep cable out of reach of children.
This product contains a Button or Coin Cell Battery. A swallowed Button or Coin Cell battery can cause internal chemical burns in as little as two hours and lead to death
Dispose of used batteries immediately. Keep new and used batteries away from children. If you think batteries might have been swallowed or placed inside any part of the body, seek immediate medical attention.
This product is not intended for prolonged periods of sleeping.
Do not move or lift this product with the baby inside it.

BATTERY WARNING

In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury or ruin your product. To avoid battery leakage, follow the instruction below.

Insert batteries in the correct polarity position (+ and -).
Do not short circuit battery terminals.
Remove batteries during long periods of non-use. Always remove exhausted batteries from product. Dispose batteries properly.
Use caution when opening battery compartment as some batteries may leak, explode or catch on fire.
Do not submerge in water or other liquids.
Do not dispose of this product in a fire. The batteries inside may explode or leak.
Only batteries of the same or equivalent type as recommended are to be used.

FCC WARNING

The device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation.

WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to connect the interference by one or more of the following measures:

Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This CLASS(B) DIGITAL APPARATUS complies with CANADIAN CAN ICES-3 (B)/NMB-3(B)

INCLUDED PARTS

Included Parts

HOW TO USE

HOW TO ASSEMBLE

Slide the seat’s frame onto the base support post.
IMPORTANT: The D-shaped anchor inside the seat’s frame must fit into the D-shaped port in the support post. Always ensure that the seat is locked securely onto the base before use
Place the reversible body pad onto the seat, then thread the harness strap through the bottom slot of the pad.
Pull the hook-and-loop strap at the top of the body pad through the ring. Fold the strap to secure its position.
Place the headrest onto the seat, then pull the hook-and-loop strap through the ring. Fold to secure.

HOW TO DISASSEMBLE

Pull the release tab out and then lift the seat from the support post.

HOW TO USE

Raise the swing lock on the back of the base to prevent the seat from moving.
IMPORTANT: Always set the swing on a flat, stable surface. Never use the seat without safely buckling your child into the harness.
Place the baby into the seat and then buckle the safety harness. Adjust the strap length if necessary. After the baby is secure, release the swing lock on the back of the base. Maximum weight 20 lbs (9 kg)
Connect the power cord to the port on the back of the display panel. Then plug the cord into an electrical outlet.
NOTE: Swing does not operate off of batteries. Power cord is the only source of power.
Touch anywhere near the center of the display panel to activate the screen.
Control the unit’s functions with the buttons indicated below:

| POWER: Press to turn power ON/OFF.
---|---
| SWING: Press to increase speed. After 5 levels, speed resets to zero.
| TIMER: Press to set time to 8 min, 15 min, 30 min, or cancel. Unit will turn off automatically when timer finishes.
| PLAY/PAUSE: Press to play built-in sounds and songs. Press again to choose next sound or song (12 total). Hold for 2 seconds to pause song.
| VOLUME: Press to increase sound volume. After 5 levels, volume resets to zero

SOUNDS:
Ocean, White noise, Rain, Heartbeat, Stream, Car ride, Birds Chirping, Fan

SONGS:
Bach, Beethoven, Mozart, Chopin

CONNECTING VIA BLUETOOTH®

The swing has a Bluetooth®-enabled speaker that can play music from a mobile device or smartphone.

Simply open your device’s Bluetooth® settings and connect to “MUNCHKIN.” The swing will chime twice when pairing is successful.

To switch back to built-in sounds, press the swing’s play/pause button.

NOTE: The swing must remain within your device’s Bluetooth® range for the connection to stay active.

USING THE REMOTE CONTROL

The buttons on the remote control function the same way as the controls on the display panel.

| Power: Press to turn power ON/OFF.
---|---
| Swing: Press to increase speed. After 5 levels, speed resets to zero.
| Timer: Press to set time to 8 min, 15 min, 30 min, or cancel. Unit will turn off automatically when timer finishes.
| Play/Pause: Press to play built-in sounds and songs. Press again to pause song.
| Next: Press to move to the next sound of song (12 total).
| Volume: Press to increase sound volume. After 5 levels, volume resets to zero.

HOW TO REPLACE REMOTE CONTROL BATTERY

Unscrew the battery compartment door using a Phillips-head screwdriver.
Insert a new CR2025 battery. Ensure correct polarity as indicated in battery compartment.
Close the compartment door and tighten screw. Do not overtighten.

HOW TO CLEAN

Washing the body pad and headrest: Machine wash cold, tumble dry warm.
Cleaning the seat fabric and swing: Wipe with a clean, damp cloth. Do not bleach. Air Dry.

ONE-YEAR LIMITED WARRANTY

Munchkin’s Swing includes a 1-year limited warranty against defects from the date of purchase. In the event of a malfunction or defect during the in- warranty period, Munchkin, Inc. at its option, will replace or repair the product under warranty. Upon receipt of the product and proof of purchase with a valid date of purchase, the defective part will be immediately repaired or replaced and returned to you free of charge (USA only). Please send defective unit, proof of purchase and a description of the problem you have encountered to:

Munchkin, Inc.
7835 Gloria Avenue
Van Nuys, CA 91406, USA
Attn: Swing Warranty

NOTE: This warranty does not cover misuse, abuse, abnormal wear & tear, negligence, environmental exposure, alteration or accident. Any alteration or removal of the product date code invalidates all claims against the manufacture.

Customer Service

TECHNICAL SPECIFICATIONS

Product Name: Swing
Model: MKCA0788 REV 1

Electrical Rating
Power Adapter

Input Voltage:100-240 VAC, 50/60 Hz, 0.2A
Output Voltage: 5VDC, 1A

Swing

Dual power inputs: Unit can be powered through micro-USB.
Micro-USB power given priority
Rated Input: 5VDC, 1A

Remote Control

Battery CR2025 button Cell

CONTACT US

If you have any questions or wish to provide comments about this product, feel free to contact our Customer Satisfaction team at 1-800-344-2229 (M-TH 8:00am-5:00pm PST, F 8:00am-1:00pm PST) or visit our website at www.munchkin.com.