KING VQ4100 Quest Satellite TV Antenna User Guide
- June 6, 2024
- KING
Table of Contents
- Quest Satellite TV Antenna VQ4100
- Quick Reference Guide
- **1. Lay the unit on a soft, non-scratching surface, and apply the 1
- **2. Place antenna unit in a location to scan for DIRECTV 101
- 3. Set up TV and receiver.
- 4. Make connections
- 5. After making connections, wait 10 seconds for the system to boot up.
- Read User Manual Online (PDF format)
- Download This Manual (PDF format)
Quest Satellite TV Antenna VQ4100
Quick Reference Guide
This Quick Reference Guide will have you watching TV in minutes!
For additional information regarding the KING Quest, see the Owner’s Manual at
kingconnect.com/support
**1. Lay the unit on a soft, non-scratching surface, and apply the 1
(3) rubber feet.**
IMPORTANT!
DO NOT apply feet if you will be roof mounting the antenna unit.
**2. Place antenna unit in a location to scan for DIRECTV 101
satellite.**
Place the antenna unit on a stable and reasonably level surface with a clear
view of the southern sky.
Be sure the surface is dry and free of loose dirt or sand.
IMPORTANT!
Antenna unit must have a clear view of the southern sky. Any tall objects can
block the signal from reaching the antenna.
3. Set up TV and receiver.
For a list of compatible receivers, go to kingconnect.com/support and click on Receiver Compatibility.
4. Make connections
Warning:
-
Place the power inserter in an accessible location.
-
Do not overtighten the coax connections.
-
Do not put sharp bends or kinks in the coax cable.
-
Do not route the coax cable where it can be tripped on or run over by a vehicle.
5. After making connections, wait 10 seconds for the system to boot up.
Press and release the power inserter button.
The antenna will start scanning for the DIRECTV 101 satellite.
WARNINGS: DO NOT MOVE THE ANTENNA UNIT WHILE IT IS SCANNING.
When the satellite is found, your programming will appear. Enjoy!
The antenna begins scanning when you press and release the button. PLEASE BE
PATIENT! The antenna may lock on the satellite in as little as 2 minutes, but
may occasionally take up to 10-15 minutes.
If you wish to start a new scan (for example, the unit gets moved and you lose
reception): press and release the power inserter button. This is the only way
to start a new scan.
The KING Quest is not programmed to lock on the 119 satellite, so you will not
receive your local channels if they are broadcast from the 119.
Access the full KING Quest manual at kingconnect.com/support. We’re here to help! Call 952-345-8147.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>