billboard BB991 Wireless Headphone Instructions
- June 6, 2024
- Billboard
Table of Contents
WIRELESS HEADPHONES
for use with Bluetootht® enabled devices
WIRELESS HEADPHONES BB991
- Charging Time: up to 2 Hours
- Talk/Music Time: up to 4 Hours
- Transmit Range: up to 33 Feet
- Bluetooth Version: 5.0
Wireless Headphones
Thank you for purchasing Billboard® Wireless Headphones. For best use of this device we recommend carefully reading this user manual and keeping it for your records
Package contains
a. Wireless headphone
b. USB charging cable
Guide
■ Headphone introduction
- Multi-Function button
- USB Charging jack
- LED indicator
- Built-in microphone
Instruction
■ Multi-Function Button Operations
Power on and off|
Hold the Multi-Function button for 2 seconds, the LED indicator will light up blue and red. To power off, hold the Multi-Function button for 2 seconds, the LED indicator will turn off.
---|---
Pairing the device|
With the headphones turned off hold down the Multi-Function button for 2
seconds, headphones will then enter pairing mode. Activate the Bluetooth®
feature on the phone, and set the phone to search for wireless devices.(See
the User Manual for your device) The headphone will show on your device as
BB991.
The next time the headphone is switched on, it will automatically search for
and attempt to connect to the last paired device.
Receive & end phone calls| Press the Multi-Function button to receive phone
calls,
press again to end a phone call.
Press and hold for two seconds to decline the phone call.
Play & Pause| In music mode, press the Multi-Function button once to pause,
and again to play. (Music will automatically pause when the device receives a
phone call)
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING YOUR WIRELESS
HEADPHONES KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Your Wireless Headphones have an internal rechargeable battery. Improper usage may result in the Wireless Headphones becoming hot, ignite or burst and cause injury if exposed to conditions of abuse. Be sure to follow the safety warnings listed below:
- Do not disassemble, throw away or damage the Wireless Headphones.
- Store the Wireless Headphones in a dry place, keeping it away from damp corrosive materials and environments such as salt air.
- Keep the Wireless Headphones away from direct sunlight, fire, and high voltage equipment. Do not store the Wireless Headphones inside a car during hot weather. Remember a closed car acts as a greenhouse allowing the inside temperature to possibly reach over 200E
- The Wireless Headphones is not a toy. Please keep it out of the reach of young children.
- Please do not discard the Wireless Headphones. Consult your local waste collection agency for proper disposal or recycling methods. You may also contact “Call2Recycle” at 877-273-2925 or online at “call2recycle.org” for a battery recycling drop-off location near you.
Charging the battery
This device has an internal, rechargeable battery.
- Plug the charger cable into the headphones.
- Connect the charger to a USB power source. The red indicator light will display during charging. If charging does not start, disconnect the charger then plug it in again, and retry. Charging the battery fully may take up to 2 hours.
- When the battery is fully charged, the red indicator light will turn off. Disconnect the charger from the USB power source and the headphones. The fully charged battery has power for up to 4 hours of talk or music time. However, the talk and music times may vary when used with different devices, settings, and music environments.
FCC Information
FCC ID 2AML6BB991
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions: (1) this device may not
cause harmful interference, and (2) this device must accept any interference
received; including interference that may cause undesired operation. Federal
Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more
of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by
the party responsible for compliance could void the user authority to operate
the equipment. Tested to comply with FCC standards. FOR HOME OR OFFICE USE.
The device has been evaluated to meet general RF exposure requirements. The
device can be used in portable exposure conditions without restriction.
It may damage your hearing if you listen with high volume for a long time.
It is recommended you use the lowest volume possible for listening to music.
Battery information
Your device is powered by a rechargeable battery. The full performance of a new battery is achieved only after two to three complete charge and discharge cycles. The battery can be charged and discharged hundreds of times, but it will eventually wear out.
Do not leave a fully charged battery connected to a charger, overcharging may shorten its lifetime. If left unused, a fully charged battery will lose its charge over time. Never use any charger that is damaged. Leaving the device in hot or cold places will reduce the capacity and lifetime of the battery. The optimal temperature for the battery is between 15°C and 25°C (59°F and 77°F ). A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Do not dispose of batteries in a fire as they may explode. Batteries may also explode if damaged. Always dispose of batteries according to local regulations. Please recycle. Do not dispose of as household waste.
Technical Support: techsupport@esicellularcom or call 212 883-8838
© 2022 Billboard IP Holdings, LLC. All rights reserved. Billboard®, the
Billboard logo, HOT 100 and associated characters, trademarks, and design
elements are owned and licensed by Billboard IP Holdings, LLC.
Bluetooth®is a registered trademark of Bluetooth SIG
LIMITED WARRANTY
ESI Cases and Accessories warrants to the first consumer purchaser that this
product, when shipped in its original container to the original purchaser,
will be free from defective workmanship and materials for one year and agrees
that it will, at its option, either repair the defect or replace the defective
product or part thereof at no charge to the purchaser for parts or labor for
the time periods described. This warranty does not apply to any appearance
items of the product nor to the additional excluded item(s) set forth below
nor to any product the exterior of which has been damaged or defaced which has
been subjected to misuse, abnormal service or handling or which has been
altered or modified in design or construction. The limited warranty described
herein is in addition to applicable law. ALL IMPLIED WARRANTIES INCLUDING THE
WARRANTIES OF MERCHANTABILITY AND FITNESS FOR USE ARE LIMITED TO THE PERIOD
FROM THE DATE OF ORIGINAL PURCHASE SET FORTH BELOW.
Some states do not allow limitations on how long an implied warranty last, so
the above limitation may not apply to you. Neither the sales personnel of the
seller nor any other person is authorized to make any warranties other than
those described herein or to extend the duration of any warranties beyond the
time period described herein on the behalf of ESI Cases and Accessories.
The warranties described herein shall be the sole and exclusive warranties
granted by ESI Cases and Accessories and shall be the sole and exclusive
remedy available to the purchaser corrections of defects, in the manner and
for the period of time described herein, shall constitute complete fulfillment
of all liabilities and responsibilities of ESI Cases and Accessories to the
purchaser with respect to the product and shall constitute full satisfaction
of all claims, whether based on contract negligence, strict liability or
otherwise. In no event shall ESI Cases and Accessories be liable or in any way
responsible, for any incidental of consequential economic or property damage.
Some states do not allow the exclusion of incidental or consequential damages,
so the above exclusion may not apply to you.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS,
WHICH VARY FROM STATE TO STATE.
Send device with the product to:
ESI Cases & Accessories
One Gateway Center,
Suite 2600 Newark, NJ 07102
- Enclose proof of purchase and $11.95 for Shipping and Handling.
TECHNICAL SUPPORT: 212 883-8838 I
E-MAIL: techsupport@esicellular.com
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>