billboard 46642 On-Ear Bluetooth Wireless Headphones User Manual
- June 5, 2024
- Billboard
Table of Contents
billboard 46642 On-Ear Bluetooth Wireless Headphones
Wireless Headphones
Thank you for purchasing Billboard Wireless Headphones. For best use of this
device we
recommend carefully reading this user manual and
keeping it for your records
The package contains
- a. Wireless headphones
- b. USB charging cable
- C. 3.5mm stereo cable
Headphones introduction
- ON/OFF button
- Micro USB port
- “V+” button
- “V-” button
- Mode
- Calling button
- Aux port
Plug the charging cable into the Micro USB charging port to act an antenna for the headphone. Short press the Mode button once to go to FM radio mode. Short press the ON/OFF button I to search for an FM station automatically, the LED light will flash blue quickly while searching for an available station. Press the V+or V- button to go to the next/ the last frequency. Short press the ON/OFF button to research available frequency.
Instruction
Multi-Function Button Operations
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE USING YOUR WIRELESS HEADPHONES KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Your Wireless Headphones has an internal rechargeable battery. Improper usage
may result in the Wireless Headphones becoming hot, ignite or burst and cause
injury it
exposed to conditions of abuse. Be sure to TolloW the sarety warnings listed
below:
- Do not disassemble, throW away or damage the Wireless Headphones.
- Store the Wireless Headphones in a dry place, keeping it away from damp corrosive materials and environments Such as salt air.
- Keep the Wireless Headphones away from direct sunlight, fire and high voltage equipment. Do not store the Wireless Headphones inside a car during hot weather. Remember a closed car acts as a greenhouse allowing the inside temperature to possibly reach over 200F.
- The Wireless Headphones is not a toy. Please keep it out of the reach of young children.
- Please do not discard the Wireless Headphones. Consult your local waste collection agency for proper disposal or recycling methods. You may also contact
Call2Recycle” at 8//-2/3-2925 or online at “cal|2recycle.org” for a battery recycling drop-off location near you.
Charging the battery
This device has an internal, rechargeable battery.
- Plug the charger cable into the headphones.
- Connect the charger to a USB power source. The red indicator light will display during charging lf charging does not start, disconnect the charger then plug it in again, and retry. Charging the battery fully may take up to 3 hours.
- When the battery is fully charged, the red indicator light will be blue. Disconnect the charger from the USB power source and the Headphones. I the fully charged battery
has power for up to 6 hours of talk or music time or up to 80 hours of standby time. However, the talk and standby times may vary when used with different devices, settings, and music environments.
Battery information
Your device is powered by a rechargeable battery. The full performance of a
new battery Is achieved only after two to three complete charge and discharge
cycles. Ihe battery can be charged and discharged hundreds of times, but it
will eventually wear out.
Do not leave a fully charged battery connected to a charger, overcharging may
shorten its lifetime. If left unused, a fully charged battery will lose its
charge over time.
Never use any charger that is damaged. Leaving the device in hot or cold
places will reduce the capacity and lifetime of the battery. The optimal
temperature for the battery is between 15C and 25C (59’F and 77F). A device
with a hot or cold battery may not work temporarily, even when the battery is
fully charged.
Do not dispose of batteries in a fire as they may explode. Batteries may also
explode if damaged. Always dispose of batteries according to local
regulations. Please recycle. Do
not dispose of as household waste. Billboard Media, LLC Billboard, and the
Billboard logo are registered trademarks of Billboard IP Holdings, LLC. Used
under license.
FCC ID: 2AML6BB7555
FCC Information
This device complies with Part 15 of the FCC rules.
Operation is subject to the following two conditions:
- this device may not cause harmful interference, and
- this device must accept any interference received; including interference that may cause undesired operation.
Federal Communications Commission (FCC) Statement
This Equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC rules. I hese limits are
designed to
provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency
energy ana, IT not installed and used In accordance with tne instructions may
cause harmful interference to radio communications. However, there is no
guarantee that interference Will not occur in a particular installation. it
this equipment does cause harmrul interference can be determined by turning
the equipment off and on, the user Is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver iIS Connected.
- Consult the dealer or an experienced radio/TV technician for help.
Warning: Changes or modifications to this unit not expressly approved by the
party responsi Dle for compliance COuld void the user’s authority tO operate
the equipment.
Tested to comply with FCC standard. FOR HOME OR OFFICE USE. radio or
television reception, which
Warning:
This equipment complies with FCC RF radiation exposure limits set forth for an
uncontrolled environment. I his device and its antenna(s) must not be co-
located or
Conjunction witn any other antenna or transmitter,
LIMITED WARRANTY
ESI Cases & Accessories, Inc., warrants to the first consumer purchaser that this product, when shipped in its original container to the original purchaser will be free from defective workmanship and materials for one year and agrees that it will, at its option, either repair the defect or replace the defective product or part thereof at no charge to the purchaser for parts or labor for the time periods described. This warranty does not apply to any appearance items of the product nor to the additional excluded item(s) set forth below nor at any product the exterior of which has been damaged or defaced which design or construction. The limited warranty described herein is in addition to applicable law.
ALL IMPLIED WARRANTIES INCLUDING THE WARRANTIES OF MERCHANTABILITY AND FITNESS
FOR USE ARE LIMITED TO THE PERIOD FROM THE DATE OF ORIGINAL PURCHASE SET FORTH
BELOW.
Some states do not allow limitations on how long an implied warranty lasts, so
the above limitation may not apply to you. Neither the sales personnel of the
seller nor any other person is authorized to make any warranties other than
those described herein or to extend the duration of any warranties beyond the
time period described herein on the behalf of ESI Cases & Accessories, Inc.
The warranties described herein shall be the sole and exclusive warranties
granted by ESI Cases & Accessories, Inc. and shall be the sole and exclusive
remedy available to the purchaser corrections of defects, in the manner and
for the period of time described herein, shall constitute complete fulfillment
of all liabilities and responsibilities of ESI Cases & Accessories, Inc. to
the purchaser with respect to the product and shall constitute full
satisfaction of all claims, whether based on contract negligence, strict
liabilities and responsibilities of ESi Cases &Accessories, Inc. be liable or
in any way responsible, for any incidental of consequential damages, so the
above exclusion may not apply to you.
THIS WARRANTY GIVES YOU SPECIFIC LEGAL RIGHTS. YOU MAY ALSO HAVE OTHER RIGHTS,
WHICH VARY FROM STATE TO STATE.
This warranty does not cover cables that have become frayed, cracked, or
broken from use. The user should immediately replace this, or any, charge
cable that has become frayed, cracked, or broken, as it may constitute a
serious safety risk, including electrocution if it is continued to be used.
Send the product with $11.95 shipping & handling fee to ESI Cases &
Accessories
One Gateway Center, Suite 2600 Newark, NJ 07102
[email protected]