VISA LIGHTING CP6900 MUSE LED Series Luminaires Instruction Manual
- June 6, 2024
- VISA LIGHTING
Table of Contents
1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting 2016
INSTALLATION INSTRUCTIONS
Model: CP6900
Fixture Family: MUSE
Document Description: Installation Instructions for
LED Series Luminaires
MUSE
Pendant
INSTALLATION & ASSEMBLY INSTRUCTIONS
Globe installation:
– Glass globes will ship separately and need to be installed onsite
– Acrylic globes will ship installed by the factory
- Carefully lift the LED Assembly inside the Globe
- Pull the power cord first through the Spun cap and then through the Nut
- Carefully rest the spun cap on the globe and hand tighten the nut into the retainer until secure.
SDC (Driver in the canopy) Option
Canopy Parts
Wiring Diagram
- Remove the Cover Screws (Bb) holding the Spun Cover (Ba). Save for later.
- Fasten the Canopy Kit (Bc) assembly to junction box (screws provided by others).
- Connect the White, Black, and Green wires per local and national codes (120/277VAC) and then push them into the junction box. Connect the Violet/Grey 0-10V dimming wires.
- Pull the fixture power cord through the center hole in the cover (Ba) and through the center clamp in the canopy kit (Bc). Tighten screws on clamp to hold the power cord down and support the weight of the fixture.
- Connect the driver wires to the stem wires. Red to White, Black to Black.
- Lift Spun Cover (Ba) in place and reinstall the screws (Bb) that were removed in step 1.
RMD (Remote Mounted Driver)
Option- Fixture Mounting:
- Fasten universal mounting plate to the junction box with the junction box mounting screws (by others).
- Adjust the height of the fixture by tightening the set screw on the side of the strain relief.
- Ensure that an Overhand Knot is above the strain relief to prevent catastrophic failures.
- Make all wire connections per local and national codes.
- Lift Canopy in place and secure with canopy screws.
RMD (Remote Mounted Driver)
Option- Driver box mounting:
Components may vary depending on the options ordered.
- Remove the cover by removing the cover screw.
- Mount remote box in an accessible area per local and national codes, use fasteners appropriate for the mounting surface (not included).
- Make all wire connections per local and national codes.
When using electrical equipment, basic safety precautions should always be followed, including the following:
- Read all instructions carefully before installing and saving for future use.
- Make sure all connections are in accordance with the National Electrical Code and local regulations.
- To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
- Service should be performed by qualified personnel.
- These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>