VISA LIGHTING CV1700 Ether Wash Instruction Manual

June 13, 2024
VISA LIGHTING

VISA LIGHTING CV1700 Ether Wash

Product Information

  • Model: CV1700 – CV1722
  • Fixture Family: ETHER & ETHER WASH
  • Document Description: Installation Instructions for Ether Series Luminaires
  • Manufacturer: 1717 West Civic Drive, Milwaukee, WI 53209
  • Contact: 414-354-6600
  • Drawing: 760470XX
  • Revision: D
  • Sheet: 1 of 2
  • Date Drawn: 04/17/14

Product Usage Instructions

  1. Secure the fixture backplate to the wall using the provided screws. Note: Longer fixture backplates are in two pieces. Install one side level, then butt the other side and level it as well.
  2. Make wire connections according to national and local codes.
  3. Push wire connectors into the wall box and align the fixture body with the backplate end tabs. Slide the fixture body onto the backplate.
  4. Fasten the fixture body to the backplate using the provided screws.
  5. Connect the two wire mate and lock connectors.
  6. Push the mate and lock connector into the fixture body, then install the front fascia onto the fixture body. Fasten it with the provided screws.

Note : On 6 ft fixtures and longer, the center of the fascia snaps into a center spring clip on the fixture body. For horizontal fixture mounting, a 2 x 4 junction box must be used and mounted horizontally. If the fixture is to be mounted vertically, the 2 x 4 box must also be mounted vertically.
For more information or assistance, please contact the manufacturer at the provided phone number.

INSTALLATION INSTRUCTIONS

  1. Secure the fixture backplate to the wall, using the screws provided.
  • Note : Longer fixture backplates are in 2 pieces. After installing 1 side level, butt the other side and level as well (see detail above). 2. Make wire connections per national and local codes. 3. Push wire connectors into the wall box, align the fixture body with backplate end tabs, and slide them onto the backplate. 4. Fasten the fixture body to the backplate with the screws provided. 5. Connect two wire mats and lock connectors. 6. Pushing mate and lock into fixture body, install front fascia to fixture body. Fasten with screws provided.

When using electrical equipment, basic safety precautions should always be followed, including the following:

  • Read all instructions carefully before installing and save for future use.
  • Make sure all connections are in accordance with the National Electrical Code and local regulations.
  • To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
  • Service should be performed by qualified personnel.
  • These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.

1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting 2004

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals