VISA LIGHTING CM2062 Overbed Behavioral Health Slot Fixtures Installation Guide

VISA LIGHTING CM2062 Overbed Behavioral Health Slot Fixtures

INSTALLATION INSTRUCTIONS

IMPORTANT INSTALLATION NOTICE:

• BEHAVIORAL HEALTH INSTALLATIONS OFTEN REQUIRE FACILITY APPROVAL AND INVOLVEMENT.
  PLEASE CHECK WITH OWNERSHIP TO ENSURE A PROPER INSTALLATION BEFORE PROCEEDING.

• Proper installation must incorporate structural blocking per guidelines below, which provides the necessary strength against unintended impact forces.

CAUTIONS :
Before affixing the drywall, loose-fit the mud flange (see) to make sure its fastener locations are clear of any interference and double check that the fixture body will clear any obstructions behind the mounting surface.
Likewise, plan drywall screw locations that will not interfere with the mud flange fasteners.
The Mud-flange forms a barrier to fluids (IP64) when installed correctly. There is to be no gaps in drywall mud to the flange lip.
** 24″ Center to Center distance provides the proper patient bed illumination at a ceiling height 6′ above the bed surface. Consult a lighting designer for other ceiling heights.

When using electrical equipment, basic safety precautions should always be followed, including the following:

• Read all instructions carefully before installing and save for future use.
• Make sure all connections are in accordance with the National Electrical Code and local regulations.
• To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
• Service should be performed by qualified personnel.
• These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.

1.  Always use the install plate to keep the MUD FLANGE square and sides from bowing.
2. After mounting MUD FLANGE, keep INSTALL PLATE in place during mudding process.
3. After mudding has dried and ceiling has been painted, remove and discard/recycle INSTALL PLATE and INSTALL PLATE SCREWS.

FIXTURE ORIENTATION

FIXTURES MUST BE INSTALLED IN THE PROPER ORIENTATION!!

1.  Each housing unit has lable indicating the “INSIDE”.

2. The “inside” labels must face each other when installed to optically perform as intended

3. Electrical connections can be made at either end of the housing units, and knockouts
   have been provided to allow separation of wires for each circuit, if desired.

4. Each housing has a slot that the lamping rests in (Detail D) and is fastened by screws  in a slot on the other side (Detail E). These features can help confirm proper installation of the housings.

LAMPING REMOVAL/INSTALLATION

1. Before installing the housing, remove lens with a small putty knife.
2. Each housing has a slot that the lamping rests in and is fastened by screws in a screw slot on the other side.
3. DO NOT HANDLE LAMPING BY THE REFLECTOR!
4. Remove lamping screws and tilt lamping out of the lamping slot.
5. Rotate lamping to allow it to pass internal housing features.
6. Reverse the process to reinstall lamping after housing installation.

1. Make electrical connections.

2. Install LAMP HOUSING into mud flange using (6) #6 flat head screws

3. Install LENS FRAME using #8 tamper resistant TORX SCREWS and plastic SCREW SLEEVES.
   Note: These Screw Sleeves are required and form part of the liquid barrier when installed as intended

4. The head of the TORX SCREW should be flush with the LENS FRAME to achieve proper ligature resistance.

717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting

Documents / Resources

| VISA LIGHTING CM2062 Overbed Behavioral Health Slot Fixtures [pdf] Installation Guide
CM2062, CM2062 Overbed Behavioral Health Slot Fixtures, Overbed Behavioral Health Slot Fixtures, Health Slot Fixtures, Slot Fixtures, Fixtures
---|---

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>