VISA LIGHTING CV1976PSX Sleight Recessed Mount Instruction Manual

June 5, 2024
VISA LIGHTING

1717 West Civic Drive Milwaukee, WI 53209
414-354-6600
Design Modification Rights Reserved
© Visa Lighting

CV1976PSX Sleight Recessed Mount

INSTALLATION INSTRUCTION
Model: Sleight
Fixture Family: Mystique
Document Description: Installation Instructions for Sleight surface mount CV1976PSX Series Luminaire

VISA LIGHTING CV1976PSX Sleight Recessed Mount SLEIGHT
CV1976PSX
CV1980PSX

SHEET 2: SURFACE MOUNT
SHEET 3: JUNCTION BOX MOUNT

****When using electrical equipment, basic safety precautions should always be followed, including the following:
Read all instructions carefully before installing and save for future use.

  • Make sure all connections are in accordance with the National Electrical Code and local regulations.
  • To avoid possible electric shock, be sure the power supply is turned off before servicing or installing the fixture
  • Service should be performed by qualified personnel.
  • These instructions may not cover all details or variations. If additional information is needed, please contact Visa Lighting.

SURFACE MOUNT

VISA LIGHTING CV1976PSX Sleight Recessed Mount- VISA LIGHTING CV1976PSX
Sleight Recessed Mount- fig

  1. Locate the desired wall opening for power feed and drill up to 3/4″ hole.
  2. Connect 24-volt power feed to fixture. Note: Excess wire can be trimmed before being pushed back into the wall.
  3. Mount lens assembly to the wall with hardware suitable for the mounting surface. Note: Make sure lens assembly is level before securing to the wall.
  4. Slide front LED assembly onto lens assembly, align posts into holes on the sides of front assembly, and secure with set screws (2).

JUNCTION BOX MOUNT

VISA LIGHTING CV1976PSX Sleight Recessed Mount- SURFACE
MOUNT

  1. Mount junction box mounting plate (requires an order of JBC option) to the mounting surface, covering the junction box (by others).
  2. Make sure the mounting plate is level, and mark the (2) holes for 16″ version or (4) holes for the 32″ version (shown).
  3. Remove the mounting plate from the wall and drill 5/16″ holes and install wall anchors.
  4. Reinstall the mounting plate to the mounting surface. Secure plate with mounting screws.
  5. Make all wire connections in accordance with local and national codes.
  6. Mount lens assembly to the wall with hardware suitable for the mounting surface. Note: Make sure lens assembly is level before securing to the wall.
  7. Slide front LED assembly onto lens assembly, align posts into holes on the sides of front assembly, and secure with set screws (2).

Read User Manual Online (PDF format)

Read User Manual Online (PDF format)  >>

Download This Manual (PDF format)

Download this manual  >>

Related Manuals