legrand WCP15 Wireless Charging Pad Instruction Manual
- June 6, 2024
- Legrand
Table of Contents
WIREMOLD®
Wireless Charging Pad – 15W
No: 1027015_RA – 0721
Installation Instructions
Catalog Number(s)
Country of Origin
IMPORTANT:
Please read all instructions before beginning installation
Legrand electrical systems conform to and should be properly grounded in
compliance with requirements of the current National Electrical Code or codes
administered by local authorities.
All electrical products may present a possible shock or fire hazard if
improperly installed or used. Legrand electrical products may bear the mark of
a Nationally Recognized Testing Laboratory and should be installed in
conformance with current local and/or the National Electrical Code.
WCP15
WPC QI – EN 62311 – ICNIRP
FCC ID: 2AU5D-LXX12
IC: 25764-LXX12
HVIN: 077641L/077642L/077643L 119-140 kHz – 42dBµA/m max.
The socket-outlet should be installed near the equipment and shall be easily
accessible. Make sure the power supply is disconnected before any
intervention. Strictly comply with instructions for installation and use.
The undersigned, LEGRAND, declares that radio equipment of the type (0 776
40L/41L/42L/43L /45L/46L/47L/48L/49L) complies with Directive 2014/53/EU. The
full text of the EU declaration of conformity can be found at:
www.legrandoc.com
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. 3
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to Part 15 of the FCC Rules. These
limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
– Consult the dealer or an experienced radio TV technician for help.
INDUSTRY CANADA – This device contains license-exempt transmitter(s)/receiver(s) that comply with Innovation, Science, and Economic Development Canada’s license-exempt RSS(s). Operation is subject to the following two conditions:
- This device may not cause interference.
- This device must accept any interference, including interference that may cause undesired operation of the device.
Caution: To maintain compliance with Canada’s RF exposure guidelines, place the unit at least 10 cm (4in) from nearby persons.
|
---|---
|
NOTE: Only one RJ45 port is used for operation, the other RJ45 port is currently reserved for future operations.
No: 1027015_RA – 0721
© Copyright 2021 Legrand All Rights Reserved.
860.233.6251
1.877.BY.LEGRAND
www.legrand.us
www.legrand.ca
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>