DIGI Haxiot HXC900 Device Developer Kit Installation Guide
- June 6, 2024
- DIGI
Table of Contents
DIGI Haxiot HXC900 Device Developer Kit
Unpack Haxiot Device Developer Kit
Package includes
- 1 x Haxiot HXC Dev Shield w/ ST Nucleo 1 x USB Micro cable
- 1 x u.FL FPC antenna
- 1 x Quick start guide
Setup and Connect
The HXC Dev shield should be pre-installed on the ST Nucleo board with the
u.FL antenna. Connect the included USB micro cable from the Nucleo to a USB
port or battery.
IMPORTANT: The Gateway must be provisioned & activated before the Device
Developer kit is activated
Enable Haxiot Cloud Service
- Ensure you have activated your Haxiot X-ON cloud account at https://signup.haxiot.com with the included activation code.
- Ensure the Gateway is on and connected.
Setup and Connect
The HXC Dev shield should be pre-installed on the ST Nucleo board with the
u.FL antenna. Connect the included USB micro cable from the Nucleo to a USB
port or battery.
IMPORTANT: The Gateway must be provisioned & activated before the Device
Developer kit is activated
Enable Haxiot Cloud Service
- Ensure you have activated your Haxiot X-ON cloud account at https://signup.haxiot.com with the included activation code.
- Ensure the Gateway is on and connected.
Provisioning Device
Load scan.haxiot.com on your smartphone using the assigned Haxiot X-ON
username and password.
Select the SCAN button to provision and test the HXC Dev shield using the QR
code label on the device. Select “LoRaWAN Dev Kit App” in the drop down.
The LED turns Purple when connected.
Caution:
The Haxiot HXG3000 Indoor Gateway is a radio transmitting device. This device
is for indoor use only. Regulatory Notices:
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.