DIGI XBee-PRO 900HP RF Module User Guide
- October 30, 2023
- DIGI
Table of Contents
DIGI XBee-PRO 900HP RF Module
Product Information
The XBee 900HP RF Modem is a wireless communication device that comes with different variants such as USB, RS-232, and RS-485. It has several components including an RPSMA antenna, power supply,USB cable (USB variant only), Mini USB cable (RS-232 and RS-485 variants only), DB9 cable (RS232 variant only), and Phoenix connector (RS-485 variant only). The modem also has several symbolssuch as RSSI LEDs, I/O LEDs, a commissioning button, a reset button, switch 1 and switch 2 for termination configuration, RS-232Serial port, RS-485 Serial port, antenna port, and a USB port.
Product Usage Instructions
- Verify the components of the kit to ensure that everything is complete.
- Identify the symbols on the RF modem such as RSSI LEDs, I/O LEDs, commissioning button, reset button, switch 1 and switch 2 for termination configuration, RS-232 Serial port, RS-485 Serial port, antenna port, and USB port.
- Connect the appropriate cables to the RF modem depending on thevariant:
- If using the USB variant, use the USB cable.
- If using the RS-232 or RS-485 variant, use the Mini USB cable or DB9 cable respectively.
- Connect the RPSMA antenna to the antenna port of the RF modem.
- Connect the power supply to the power supply port of the RF modem. The power supply must be between 7-30 VDC.
- If using the RS-485 variant, connect the Phoenix connector tothe RS-485 serial port.
- Configure the RF modem by setting switch 1 and switch 2 for termination configuration.
- Once the RF modem is connected and configured, go to www.digi.com/products/xbee-rf-solutions/modems/xbee-pro-900hp-rf-modemsto get started with your kit.
- If you need technical support, contact Digi Technical Support by calling 877.912.3444 or visit www.digi.com/support for more information on technical support plans and pricing.
- If you have any feedback on the documentation, send your comments to techcomm@digi.com.
Verify the components
- XBee 900HP RF Modem
- USB cable (USB variant only)
- Mini USB cable (RS-232 andRS-485 variants only)
- DB9 cable (RS-232 variant only)
- RPSMA antenna
- Power supply
- Phoenix connector (RS-485 variant only)
Symbols on the RF modem
RSSI LEDs
I/O LEDs
Red – Association
Green – Transmit from host
Yellow – Receive from host
Commissioning button
Antenna port
Reset button
Switch 1 – termination for 2-wire configuration
Switch 2 – termination for 4-wire configuration
Power supply (7-30 VDC)
USB port
RS-232 Serial port
RS-485 Serial port
Next steps
- To get started with your kit go to: www.digi.com/products/xbee-rf-solutions/modems/xbee-pro-900hp-rf-modems
- Digi Technical Support: Digi offers multiple technical support plans and service packages to help our customers get the most out of their Digi product. For information on Technical Support plans and pricing, contact us at 877.912.3444 or visit us at www.digi.com/support.
- Documentation feedback: To provide feedback on this document, send your comments to techcomm@digi.com.
© 2016 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered
trademarks in the United States and other countries worldwide. All other
trademarks mentioned in this document are the property of their respective
owners.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>