C3 HD Backup Camera for Momento R1 User Guide
- October 27, 2023
- MOMENTO
Table of Contents
C3 HD Backup Camera for Momento R1
Introduction
The Momento C3 HD is a compact, backup camera that connects to the Momento R1 Rearview Mirror Replacement solution (sold separately). Through a simple connection to the R1, the C3 HD camera automatically activates when the vehicle is in reverse gear.
PackageComponents
- C3HD Backup Camera
- 20-ft Harness for R1 Connection
- 4-ft Extension Cable
- Adjustable License Plate Mount
Specifications
- Optical Format: 1/3 CMOS
- Resolution: 1080p
- Viewing Angle: 170 degrees
- Automatic Gain Control & Automatic Backlight Compensation (AGC / ABC): YES
- Minimum Illumination: 0.1 Lux / F1.2
- Power Supply: DC 12V +/- 10%
- Operating Temperature: -25º to 70º C, -13º to 158º F
- Waterproof Rating: IP69K
- Mirror + Normal Image: YES
- AHD + CVBS Selectable Signal: YES
Installation
- Find a suitable location to mount the camera. See below.
- Once you have the camera mounted in your location of choice, route the camera wiring into the vehicle. If necessary, drill a hole to run the camera wiring into the vehicle. If you use this method, please use a rubber grommet to protect the wiring.
- Once you have the camera’s wiring in the vehicle, connect the camera to the Image selector box. Run the rest of the wiring through the vehicle and connect the Yellow RCA (male) to the Momento R1 Video 1 or 2 Input.
Mounting Tips
- Loosen the screws on the license plate with a wrench.
- Install the C3 HD camera bracket behind the license plate. If necessary, adjust the C3 camera horizontally by unscrewing the two screws directly below the camera.
- Replace the license plate over the C3 HD camera bracket, and tighten the screws with a wrench.
Reverse/Forward Image Selection
By default, the Momento C3 HD will automatically mirror the video image for
the backup camera. To choose a normal image for the front camera, cut the
white wire.
Wiring
- You will notice there is a red wire at the power box, as well as the Yellow RCA output. This is the same wire. This allows you to find your power source at either end of the wiring harness. Whichever end you do not use, be sure to insulate with heat-shrink or electrical tape.
- The reverse lamp wire may not provide sufficient voltage to the camera; please use an extra relay.
- Black (Ground) – Find a suitable location to ground the Black wire in the wiring harness.
- By default, the C3 HD’s video output is for HD monitors only. To connect the C3 HD to a CVBS non-HD monitor like the Momento R1, please cut the green wire.
21903 68th Avenue South
Kent, Washington 98032
Toll-Free: (888)820-3690
Monday-Friday 8 am-5 pm Pacific (US)
This device has been designed as a driver’s aid and must not be considered infallible. Always reverse vehicles with caution and use common sense. Manuever your car slowly in the interest of your own safety and that of others.
References
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>