SIGMA 00481 Silicone Mount Rear Light User Manual
- June 6, 2024
- SIGMA
Table of Contents
SIGMA 00481 Silicone Mount Rear Light
SIGMA-ELEKTRO GmbH
Dr.-Julius-Leber-Straße 15
67433 Neustadt/Weinstraße, Germany Tel. +49 6321-9120-118
kundenservice@sigmasport.com
UKCA STATEMENT
We, SIGMA-ELEKTRO GmbH, declare that the equipment above has been tested in
our facility and found compliance with the requirement limits of applicable
standards, in accordance with the Radio Equipment Regulations 2017 and the
Restriction of the
Use of Certain Hazardous Substances in Electrical and Electronic Equipment Regulations 2012. The test record, data evaluation and Equipment Under Test (EUT) configurations represented herein are true and accurate under the standards herein specified.
CE INFORMATION
SIGMA-ELEKTRO GmbH hereby declares that the BLAZE FLASH complies with the
fundamental requirements and other relevant regulations of Directive
2014/30/EU and RoHS Directive 2011/65/EU. You can fi nd the CE declaration at:
ce.sigmasport.com/blazeflash
MOUNTING
Do not cover the rear light!
- Before mounting, clean and degrease the seat post to ensure a tight fi t. When fixing the device, ensure that the silicone strap is tight enough that the rear light cannot move on its own and is not easily moved. Mounting height between 250 -1200 mm.
- The BLAZE FLASH is a self-calibrating kinetic brake light that is also equipped with a brightness sensor. During calibration, the yellow indicator LED (Fig. 1) flashes for about three seconds, then lights up continuously, indicating AUTO mode.
ALIGNMENT
Final side of the tail lamp perpendicular to the roadway and at right angles to the vehicle center axis.
BUTTON
BATTERY INDICATOR
The battery needs to be charged immediately if the monitoring device/blue
indicator has been activated. The LEDs are not replaceable.
If an LED fails, replace the tail light.
CHARGING
- Ensure that the sealing marked red is always closed correctly after charging.
Energy extraction through the Micro USB port is not possible. These lamp needs to be replaced in case of defective light source.- During charging, the battery monitoring system lights up yellow. If the battery is ready for use again, the battery monitoring system goes out.
LED MODE
AUTO MODE
When braking, all 3 red LEDs light up for approx. 3 sec. The AUTO mode
indicator lights up yellow.
STANDARD MODE
The rear light is switched on.
When braking, all 3 red LEDs light up for approx. 3 sec. PULSE FLASHING
The fl ash mode is switched on.
When braking, all 3 red LEDs light up for approx. 3 sec. 
ECO FLASHING
The fl ash mode is switched on.
When braking, all 3 red LEDs light up for approx. 3 sec.
Read User Manual Online (PDF format)
Read User Manual Online (PDF format) >>